Forum: Engines

I am putting a 72 Trail Boss back together and do not know where to hook up the 2 gas lines at. There is a quarter inch nipple on the engine block...

I know this has been done many times, but I'd like some pointers as to where to start. My 04' Max IV has all the power you need about 90 percent of...

After going through the fuel system on my "new" Conquest, I pulled the plugs and found the front one to be black around the base ring and the tip was...

Guys, I need help. I have a '98 response with the 18hp b&s. Was turning over and starting fine. My son drove around our property in the deep,...

As part of my Hustler rebuild I am letting the high school small engine shop class check out my 16hp B&S. On Cyl A they found a broken ring, piston...

Does anyone have the NAPA p/n for an oil filter for a Kawasaki FD620 used in Argo Conquests amongst others, Thanks, Joe.

Had to buy a new carburetor for 20 hp. Kawasaki Slap it on runs great until I get to steep incline or decline and it dies . Any idea how to fix this?

I recently inherited a broken down argo six wheeler. So I'm new to the Six Wheeler world. For some reason fuel is not getting to the carburator. I'm...

NOTICED THAT THERE IS ALWAYS OIL IN THE AIR FILTER HOUSING.SEEMS TO BE COMING OUT OF BREATHER TUBE THAT IS ATTACHED TO BOTTOM OF AIR CLEANER...

hey all I have a kabota v1505 turbo deisel in my predator and my temp guage is acting goofy. The temp sensor is located in the housing right near the...

Tonight I had the breather off to clean bad gas out of the carb. Another story. I dropped one of the bolts and it was wedged between the flywheel. I...

when it rains it pours. all of a sudden my Max IV started running rough. My neighbor said I had "Green gas " in it get it out. It was back firing...

I read on a forum a while ago about how you can mount a starter off a Honda car on a Kohler 440 2 stroke but i can't find the post. Anybody ever...

Having trouble with my 16 hp tecumseh engine....It idles fine and I can give it full throttle with no problems in neutral....When I put it in a...

I am thinking about picking up one of the cheep Honda clone motors to put in my first gen attex st300. What drive clutch are you using or which do...

Hello everyone, i found this website just browsing the world wide web looking for a Rev kit that Lewis and the guys was talking about when i was...

I see everything new and a lot of machines modded. I recently bought a 1300 scrambler it has a stock 7 hp briggs pull start and no electrical...

hello everyone, i just finished rebuilding my jlo440 and installed it back in the bigmax. i tried to start it but cannot get it running. if i...

Im trying to get a little more kick out of my 16hp vanguard. Im thinking about the hi rev kit, is this a good idea? Or can I tweak my governor some?