Forum: Engines

Does anybody know of a points to cdi conversion for a Sierra Trail Boss with a Kohler 295-1? It's a single cylinder 2 stroke. I've heard of using a...

Ok I am riding along and everything is fine. See another guy with an Argo and stop to chat for about 15 mins. Go to start up again and Conquest...

Hey does anyone know if the predator or duromax engines have charging systems it dosen't show one on their specs

Service time... yuck... I always dreaded the messy fluid change. It always seemed that no matter how much care I took to prevent it I wound up with...

Hi Folks, My Argo Magnum (18 hp Kohler) has a wonky regulator/recitifier - it has been working intermittently for a while. I'd like to change it....

Helpp ??!!! This carb is driving me nuts - It's a Tillotson HR 31A and I have issues with it ( aside from my own issues ;) It wont keep the fuel...

Ok i'm trowing in towel and asking for help! I have a RIM from what I can tell it has the original G50B still in it I have replaced the crank seal on...

I have a couple of questions.... 1. what is the best way to tune the briggs 18hp for higher elevations ( 9,000-10,500 ft) I live at 5500 ft and it...

Hi. Can someone tell me what the Compression figure should be when I do a compression test on a Tecumseh OH160? Thanks Rob

I have a 1989 Max IV with a B&S 18hp Vanguard. I am looking for easy ways to gain some HP. I heard about putting the 23HP cam in my engine. I am...

HI all, have a 1993 briggs vanguard 12.5hp v-twin engine in my MaxII. When the air cleaner is on it chokes the engine out, blows black smoke and has...

I just changed the oil on my bigfoot and like everyone says not easy. Used a ziplock bag and still a pain. Has anyone given any thought to adding a...

It is prob in here some where but until I learn how to find it I do it this way has envy one ever installed a fuel gage in there Argo or something...

I have a question about the stator in a 10hp,vert shaft,I/C engine (second hand) that I installed on my lawn tractor which is used only for pushing...

300 Attex - pulled the engine few months ago- tore it apart - rebuilt with seals and bearings - seals were tore up - Had to make a new engine plate...

What temp should these engines run at? Mine is running very hot. I've rejetted it some but still it hot. This is in my attex. What can I do to...

Well took the gears off the starter in my 1990 vanguard.with a 16 twin briggs.still turns over.why they make it out of plastic.has anyone replaced...

Hello, I purchased an older argo 8x8 (early 1970's) a few months ago. When I purchased it everything ran fine. It sat around for a couple months,...

Hello i am installing a 15 hp honda clone to replace a tired tecumseh and i hooked up a mikuni fuel pump to the engine by installing a pulse line in...