Forum: Engines

I have lost my spark and now I need to pull the flywheel. Tried for over an hour with a puller and impact. No luck. I only keep breaking the 6mm...

Hey Guys, new here to the forums, found you from a google search. Ive got a argo conquest that sat for a while and gummed up the carb. I took the...

Can anybody tell me The Briggs stratton part # for the governor spring black its the one that gos to throttle and governor argo part #805458. A...

I know this has been done many times, but I'd like some pointers as to where to start. My 04' Max IV has all the power you need about 90 percent of...

so I bout 2 coils to replace mine,lost spark on the right lung. Can anybody tell me the correct wiring for the coils?!?!? thanks once again guys

Was wondering if I wonted to get a little more hp out of my 16 hp Briggs what would be the easiest way to get it or can this even be done?

ok got a duromax 4 stroke engine, still lookin for a clutch does anyone know and have some pics on how to set up a trhottle on these? the factory one...

Looking to see if anyone has had this problem? I installed an 18 hp Briggs in a Max 11,, I started the engine and run it for about 2 minutes, just...

I have a single cylinder Rockwell JLO 396cc engine that I'm getting ready to overhaul. I'm going to need a piston, rings, gaskets, crank seals,...

I was wondering if some one had all the specs for the carb main jet, pilot jet,jet needle,needlejet,throttle valve, and needle and seat size. Thanks!!

hey all I have a kabota v1505 turbo deisel in my predator and my temp guage is acting goofy. The temp sensor is located in the housing right near the...

Hi All I am thinking about replacing my 18hp briggs ( 31 lbs TQ ) engine with a 18.5 Yanmar diesel engine ( 37 lbs TQ ) less RPM, less fuel usage...

I have a early/mid 80's Hustler with a Briggs 18HP I-C flathead motor. Can anyone tell me if the engine has to come out to adjust valves? I've never...

I recently joined the AATV ranks when I bought an AC Terra Tiger. All hasn't been rosy tho. Got some debris in the carb, and it basically poured...

Can someone provide me with some info on this Governor linkage setup? I think I am missing some pieces. See picture. The throttle cable...

Hey guys, new to the site, just bought a max iv with an 18hp vanguard a few weeks ago and the site has been a huge help so far. I have tried to...

Hi All I have a issue with my 18hp Vanguard and I will try my best to put all info in the post. 1. year 2000 vanguard 18hp 2. year 2000 max II 3....