Forum: Engines

I am thinking about picking up one of the cheep Honda clone motors to put in my first gen attex st300. What drive clutch are you using or which do...

Having trouble with my 16 hp tecumseh engine....It idles fine and I can give it full throttle with no problems in neutral....When I put it in a...

I read on a forum a while ago about how you can mount a starter off a Honda car on a Kohler 440 2 stroke but i can't find the post. Anybody ever...

when it rains it pours. all of a sudden my Max IV started running rough. My neighbor said I had "Green gas " in it get it out. It was back firing...

Tonight I had the breather off to clean bad gas out of the carb. Another story. I dropped one of the bolts and it was wedged between the flywheel. I...

hey all I have a kabota v1505 turbo deisel in my predator and my temp guage is acting goofy. The temp sensor is located in the housing right near the...

NOTICED THAT THERE IS ALWAYS OIL IN THE AIR FILTER HOUSING.SEEMS TO BE COMING OUT OF BREATHER TUBE THAT IS ATTACHED TO BOTTOM OF AIR CLEANER...

I recently inherited a broken down argo six wheeler. So I'm new to the Six Wheeler world. For some reason fuel is not getting to the carburator. I'm...

Had to buy a new carburetor for 20 hp. Kawasaki Slap it on runs great until I get to steep incline or decline and it dies . Any idea how to fix this?

Does anyone have the NAPA p/n for an oil filter for a Kawasaki FD620 used in Argo Conquests amongst others, Thanks, Joe.

As part of my Hustler rebuild I am letting the high school small engine shop class check out my 16hp B&S. On Cyl A they found a broken ring, piston...

Guys, I need help. I have a '98 response with the 18hp b&s. Was turning over and starting fine. My son drove around our property in the deep,...

After going through the fuel system on my "new" Conquest, I pulled the plugs and found the front one to be black around the base ring and the tip was...

I know this has been done many times, but I'd like some pointers as to where to start. My 04' Max IV has all the power you need about 90 percent of...

I am putting a 72 Trail Boss back together and do not know where to hook up the 2 gas lines at. There is a quarter inch nipple on the engine block...

Pro & Cons - Kawasaki 20 HP FB460V vs B&S Vanguard V-Twin OK folks, what are some of the PRO's and CON's of these engines. The B&S is in a...

Hi folks...anybody got the stock jetting for the 295 rockwell with the mikuni vm30-16...i didn't see it in the manual page..i pnly found ther main #

Well i finally picked up another rotax with the starter and flywheel i needed to add to the Bazooo so no more pull starting for me.:D Now i can...