Forum: Engines

Got a hustler 945hk wondering about factory specs on motor oil capacity.

this sounds like the right place to post my question(s). i have an early maxll with a 440 kaw that locked up.ive been told "nobody" can get rebuild...

couple of questions : what size is the clutch shaft on a k440 : can I used the same clutch :hmmmm2:

Hey guys I have an old 18 hp tecumseh that I'm working on. It's an overhead valve engine. It has a little two inch breather tube on top of the...

I searched for an answer but could not find one. As a new owner of an Argo conquest I am wondering about using "Normal" gas. All seem to have up...

i just bought a max iv and i love it. it came with 21' tires and i dont have alot of ground clearance so i get stuck in a mud puddle lol. i need to...

Ok my 295 wild wolf has no motor and my options are a 11hp horz tecumsu or a 19hp vertical Craftman/Briggs. I had never heard of converting a vert to...

Hey Guys, new here to the forums, found you from a google search. Ive got a argo conquest that sat for a while and gummed up the carb. I took the...

Hello everyone, IT has been a VERy long time since i posted last. I am still messing with my BIGMAX. I finally have all of the parts to put the...

I found a 30 hp Bandolero engine for $500 on ebay. What I want to know Will it fit in my 1996 argo bf and will my cluch work I have an 18 hp briggs...

Could someone please tell me the crank size of a jlo 440 & will a 30mm and 25 mm salsbury both fit ? Thanks!! both of these clutches are listed on...

I'm rebuilding my jlo 440 & my brain can't remember removing the old seal. when installing the new one does the flat side go in facing the crank or...

Hey guys I am having trouble getting my carb dialed in it seems to be running rich and it stalls out sometimes when I'm plowing snow or rev the motor...

so I bout 2 coils to replace mine,lost spark on the right lung. Can anybody tell me the correct wiring for the coils?!?!? thanks once again guys

Well I figured out why my old Kohler wouldn't start. I knew the compression was low on 1 cylinder and pulled the head but the piston & rings looked...

Does anyone know any particular issues with the stock 20hp conquest motor? Like weak spots or maintenance problems? Maybe even carb or ignition...

I have a 2007 Argo Avenger 700 Carb. type It started coughing and sputtering... Then quit. I changed plugs, and when checking fuel filter found...

Im looking to replace my 18 hp briggs with a 23 hp briggs and I think the 18 motor has a 2 29/32 shaft 1/4 key & 3/8 taped end and the 23 has a 3...

Anyone familiar with the valves adjustment of the Kohler M18? Do they have the normal tendency of gap tightening? Can they be adjusted without...

went for a ride today on the machine and noticed the intake was freezing up on me! why would this do this? you could see the frost on the intake and...