Forum: Engines

Hey guys, this is my first post here. I picked up a max 2 a couple of weeks ago with a 16 briggs in it and I love 6 wheeling. My question is that I...

I see harbor freight has a 22hp predator v twin. Anyone have any experience with this engine?

I have an old Argo TB 8X8 with the Tech. engine. The oil temperature gauge has just stopped working. I was hoping someone would know the temp...

I posted this in the welcome thread and was advised that I might have more luck with my question here. I am getting towards the end of getting my...

I'm looking for a exhaust pipe and a clutch for a what I believe to be a Kohler K295-1T. Any help or direction would be greatly appreciated.

I know it depends on how it was taken care of during its use but is there like a rule of thumb like rebuild or replace every 800 hours for example?...

This has been bothering me for a long time. What if your out in the middle of nowhere and you blow the belt. What is the best way to get the new belt...

Made a Dial indicator setup for timing my G50B from an old plug a piece of 3/8" fuel line and a dial indicator with an extension. The hardest part...

Dropped a phillips head bit on top of the engine (23 hp Briggs). Looked down in time to see it go thru a little opening right below the carb. No way...

Has anyone wrapped thier 2 stroke pipes with exhaust wrap tape to help cut down on heat?I have seen this done on 4 strokes but didnt know about 2...

I just got my argo up and running again and the throttle is sometimes getting stuck at a high RPM and I have to rev really high and let go quick for...

Scat Male/Female engine mount Just found these, someone may need a few.

Hello, I have a "new to me" 2006 8x8 Avenger, and I am wondering what the normal operating temperature is for the 680 water-cooled Kohler? I...

Hello everyone, IT has been a VERy long time since i posted last. I am still messing with my BIGMAX. I finally have all of the parts to put the...

I've got a 400cc kohler motor with a tillotson HR carb on it. I just put a carb kit in it and I thought it would work. When I put gas to it, it...

So I put a Governor lock on this 35HP Vanguard that Im Modding. I removed all the stock linkage to do the Carb swap. Im playing with an automotive...

I just went for a ride and when I got back I heard a bit of a whining/grinding. Looks like my clutch is rubbing on the rotor. Is this adjustable or...

Are there many members out there running synthetic oils in motors and transmissions? Some folks I have talked to say it will eat gaskets, any...