Forum: Engines

Hi Guys, I am looking for some input on the easiest way to remove the two bolts that hold the carb to the intake manifold. They are bolted up...

Got a hustler 945hk wondering about factory specs on motor oil capacity.

Hey guys,i'm still gettin gas in my oil pretty bad on my argo conquest,i was wondering if anyone can tell me where the model number is located on the...

Hi Every one does anyone know the best way to replace crank bearings on Jlo 440? is the center one replaceable? Looks! impossible Thanks! Randy

Well I figured out why my old Kohler wouldn't start. I knew the compression was low on 1 cylinder and pulled the head but the piston & rings looked...

just put in a new mtr brigs v twin 18hp. with mtr running volt meter on bat how manny volts should meter show? the meter showes to jumping all...

Motor will start and run but backfires and won't idle also does not want to go in high gear bogs down. What could this be? Just cleaned carb and new...

Ok so on my recently free argo, I've discovered the motor in it is a Chapparal G44b. This thing has probably been sitting for about 20 yrs. I got it...

I can't find one anywhere

Does anyone know a easy way to get more power from a 20hp kohler motor? Can the governor be adjusted? If anyone knows how to do this please post some...

Im trying to get a little more kick out of my 16hp vanguard. Im thinking about the hi rev kit, is this a good idea? Or can I tweak my governor some?

I am in the process of rebuilding 2 JLO 440's. with the 6 bolt head. The first question is: How to make, or where to buy tools to pull flywheel and...

Does anyone have the NAPA p/n for an oil filter for a Kawasaki FD620 used in Argo Conquests amongst others, Thanks, Joe.

trying to figure out what sachs motor my amphicat has thought it was a 292 but i can only find a Arctic Cat 292. im in need of a new head gasket...

I have a 1970s argo with a Kohler engine. The Bosch starter isn't working so I pulled it off, but now I can't get it apart to clean the brushes. I...

Hi guys. I got a 1986 Hustler 900 with the chaparral g50b 484cc twin 2 stroke engine. I idles nice, but when I hit the throttle, the engine revs...

Got a line on a used 20 hp intake and 2bbl carb but it is off of a vertical shaft engine. Is it possible to use these items on my 18hp horizontal...

Hello, I just purchased a used Honda gx620 to replace my 17 hp twin kohler on my 6x6 argo. Actually my other half bought it for me as I am away for...

OK other than the HP what is your all thoughts for a Max II. Has a 14 Briggs in it now But I have a Real nice 18 Kohler command I was going to put...