Forum: Engines

Just wondering if this be enough? Piaggio X8 125cc Vacuum Fuel Pump | eBay I've tried it with an electric fuel pump and a boat hand pump but no...

my 2007 argo with brigs 23 hp has been hessating when I turn the key nothing and turn again battery is full and then like magic try 4 or 5 more times...

I have what appears to be a good Sachs engine. (Turns over really nice, good compression, Etc.) The guy I bought it from sais that it ran well and...

has anyone put in a chip to increase performance for their argo. i am considering this to add 15% (manufacturer claims). My Argo has 31 hp. Kohler...

trying to figure out what sachs motor my amphicat has thought it was a 292 but i can only find a Arctic Cat 292. im in need of a new head gasket...

:hmmmm2:My gas cap on my six was bad so I went to Fleet Farm and bought a new one. I didn't drive my wheeler for about 2 weeks. I went out riding and...

Hi there. Just picked up a 95 max in great condition. Only problem I have is the motor stalling out after I hit a few good bumps. I pull the choke...

It's been awhile I had a new shoulder installed.Mean while my hustler rebuild was put on hold and I purchased an max II.I haven't got to use it much...

Dropped a phillips head bit on top of the engine (23 hp Briggs). Looked down in time to see it go thru a little opening right below the carb. No way...

Hi, I have a mid 90 MaxII with a Briggs 16hp vanguard. I have the transmission out for repair and also removed the engine to replace the starter....

I have a Kohler Command 20HP. On the tail end of a 2 hour ride my engine started to sputter for a few seconds and then turned off. It seemed like...

I've been looking for a L297 piston and cylinder without luck. Was wondering if a 297/300 cylinder and piston would work, understanding I'd have to...

Is Max out of business?

Need recommendations for a good place to buy a rectifier online.

Im getting an 18hp kohler magnum tomorrow, I think it has an inch and one eigth shaft....

Hi: Since I am in the process of restoring my 295 Wild Wolf I don't want to put in a non-original (ie other than a JLO 295) engine. But I would...

I have a B&S 16hp vanguard that did not have the air box on it when i bought it. There is a small barbed vacuum connection close to the top of the...

Hi, I've been rebuilding my 6X6 over the winter and it's almost ready to go. The oil dipstick is broken from the bottom of the oil cap on the...

Hi folks...anybody got the stock jetting for the 295 rockwell with the mikuni vm30-16...i didn't see it in the manual page..i pnly found ther main #