Forum: Engines

Fellow Owners, I ran across a guy whop has used VMAX batteries and was wondering if anyone else has used them in their 6 x 6 and how did they...

anybody have a running or rebuildable core for a kohler 399 cc 2 stroke 2S

What are plastic jets used for? I bought some vintage Mikiuni and Keihin complete selections of jets and some are plastic and wondering what they...

Hi All I have a max iv and to be honest the very old engine on this is being a real pain in the ass, i have the opportunity to get a replacement ,...

Have just partially rebuilt a Kohler KT17, using new battery, coil, leads, condenser and plugs. Checked voltage is getting to coil from RUN position,...

I have an old Argo TB 8X8 with the Tech. engine. The oil temperature gauge has just stopped working. I was hoping someone would know the temp...

Hey everyone, I'm at a stopping point in this project. The 4 allen head socket cap screws holding the fan housing to the crankcase I can't break...

I recently picked up a WG750 Kubota gas engine. It was the power head for a generator. But by the the time it found its way to me it was just the...

Does anyone reproduce the rear rubber motor mounts for an Attex 297?

If I don't keep the battery of my Max IV on a battery maintenance charger( 2amp) it will be dead in about 3 weeks. I am on my second battery from...

Hi, I've got a JLO 2F 400-2 and I have lost the keyway for the fly wheel. Where can I find the size and where can I purchase one. Thanx

Hi everybody I’m having some trouble with my Tecumseh 18hp engine it will not start I’m getting plenty of gas to the carburetor bowl but it’s...

Hey guys. I am having some trouble with my conquest. Bought this a year ago and when I got it I replaced the entire fuel system and lines. Rebuild...

I have a 2017 Frontier S 8x8. Is there a way to get the oil filter off with out taking everything apart ? I can get my hand on it but not enough to...

Hi guys. Haven't been on here in a while and I'm a little stumped. I've got a 1970 kohler 400 two stroke and when I'm standing beside the Argo with...

Thought this would probably be the place to put this post. I bought a machine that needs a fair amount of work. All axle bearings and seals, just to...

Need recommendations for a good place to buy a rectifier online.

Hi I’m looking to replace my throttle cable on my max ll from a 9ft to a 5ft heated cable I was wondering if I can use the cable to an aluminum...

Rebuilt a Cuyuna 440. I used the JLO book and it says .083"-.102" so I set the timing at .090" and it acts like it wants to start but I can't get it...