Forum: Max ATVs

Has any one hooked up a disk harrow to there 6X6? looking to do a food plot for Deer.

Got bored today and scrounged around for stuff to do and this is what I came up with. should help get the heat out of the engine bay a little easier....

Im in the process of re-doing the bearings on my '94 Max ii. And it appears the previous owner put in a new axle which is roughly an inch longer than...

I have an 07 max iv and when i bought it the factory sprockets had been changed. What is the factory tooth count for "all" of the sprockets on this...

I have a roll bar for a maxll. Mine is in three pieces, comes apart near the holes in the top part of the body. There is a pipe that is bolted inside...

Hi all, Model: '94 Max II Serial: 10608 I'm about to redo all of the bearings for the axles and would like confirmation I have selected the...

Hey guys i was wondering where i can buy some triple sealed bearings for my 1996 max IV? From the info i have gathered they are 72mm. And should I go...

Hi All Does anyone know the approximate chain tension force on the #520 chain on a MAX II. I am thinking between 6 and 9 lbs. Would this be...

HI All After several hrs of researching parts for my overhaul I have decided to use these parts and venders for my overhaul, I hope this will help...

Hi All I have a 2000 MAX II and I am looking for the correct center to center spacing on my engine shaft to T20 shaft to insure I get my belt set...

hey friends, when installing the bearing in the bearing flanges on the max 2 or others i know you have to grind that little pin flush in order for it...

Just bought a 97 Max IV with a Koehler commander 20hp. At full throttle the belt is 1.5 below the top of the clutch. Belt seems to be tight enough....

Yesterday I was doing some heavy towing w/ swisher brush cutter and when I took on some hills, after running for a couple hours, I got some smoke. ...

I All I am trying to remove all my axels (2000 MAX II)and all I have left is my center ones. I do not see any set screws or any other type of...

I've got a bad carb on my 14hp vanguard And was looking to upgrade to a 16hp carb. Anyone have part number . Also if you know the part number for...

Hi All I have a 2000 MAX II and I am completely overhauling it. All the set screws on the brake rotors, locking collars and gears need to be drilled...

Hi All If I am unable to remove the set screws on my sprockets I will be cutting them off.( my patience is wearing thin) where is a good place to...