Forum: General 6x6 ATV Discussion

I understand that these machines can be hard to get in reverse. When I first got it I could rock it around and make it go in reverse. I haven't been...

22hp predator. I had the machine in a 45 degree angle while going through a ravine and the low oil switch shut it down. Rolled back and started it on...

Have a 20 hp Briggs. Just wondering if anyone plowed with one in snow deeper than a few inches? If so, what plow blade did u use? Thanks

First time out in the snow. Have the tracks on. Warmed up to -11 degrees celcius so was a nice day for a ride.

that video of this german x cat 8x8 machine is pretty cool design. check it out if you have'nt seen it. johnboy va.

My 1997 Bigfoot chronically pulls to the left, so much so that I am constantly bumping the right brake to keep it chicken tracking down the trail. I...

This past weekend I went to a local auction and purchased a max 2 serial # 7132 . It is missing the motor, seat, gas tank and has no wiring . But it...

Fellow Owners, I purchased a Huskie battery made by Excide at a local TSC store on 7/31/17 and it won't hold a charge. Took battery back to the...

Pulled the chains off my new argo to clean them today. I was struggling with the first one and was confused why till I stuck my head down there to...

So I was thinking that I might buy some old 8x8 or 6x6 and then rebuild it into a tracked vehicle. I was thinking about using tracks from a BV-206...

never owned an Argo Looking at a used 2002 Vanguard with little over 100 hours (per the meter) Things to look for? any major likes or dislikes?...

Hello, does anyone out there know what parts are compatable between a swamp fox and a max2 I’m pretty sure the tranny anything else?

Has anyone ever attached a dump bucket to front of argo 8x8? Can the winch and frame handle a dump box weight. The dump box I plan on attaching...

Does anyone here have or had experience with high revving 2 strokes mated to aggressive mud tires such as Executioners, Vampires, ect in swamps or...

the axles on my max2 are on my subframe and do not come thru the tub. if the holes on my frame where the bearing flanges bolt thru were slotted .....

Hello. I just got this 6 wheeler. I'm working on restoring it. The 6 wheeler has a 13hp motor on it, everything looks good the most part except the...