Forum: General 6x6 ATV Discussion

curious to if anyone has used the plastic welding kits on repairing their attex and if so how well has it held up and where can i get one for a cheap...

Hi everyone, Has anyone had sucess with welding patches on the lower body of the argo? How strong are these welds? Thanks Newfy Moose

I found a bunch of good info at the Plastic Fabricator magazine website Here on welding and repairing plastic... wanted to add it to links or...

I have 30mm thick clear plastic windshield and side curtains that have a fogging problem, is there something I can spray on them to help?

Yesterday, I took my son out to ride his dirtbike and I took my argo along so I could keep a close eye on him. There was a guy who brought out his...

Looking to put a plow on my conquest 8x8. How big/heavy of a plow will these machines handle? I see the plows sold for them are about 170 lbs and 81"...

Has anyone tried plowing snow Both with tracks and withouth tracks. I would like to know if it would be worth trying without tracks. I know with...

Wife and I are looking at 6x6 and 8x8, but how well do they plow snow, light fluffy, wet and heavy. Small amounts or 6" to 12". Does the engine...

I'm new to this, but have been looking into an argo to be used primarily for plowing snow out of an irrigation ditch in the spring. There would be...

I'm wondering which brg in your expirience has been the one giving you problems on tracked units or units that have three brgs on each axle which...

Just seeing what people beleive the main cause of outer axle bearing failure is on AATV's. Contamination (water, dirt, ect), or structural (bearing...

Hi, we can see very nice video's on atv's on this site. But on some of them we can see pop cans, beer cans and so on floating all around in pounds,...

Well I found a hairline crack towards the top of my plastic poly fuel tank in my Attex racer. I'm guessing its from sitting out in the cold and the...

-Only repair Polyethelene with Polyethelene -Heat an iron to 475-525 degrees -Apply heated iron to both surfaces simultaneously(one side of iron to...

So I was thinking that I might buy some old 8x8 or 6x6 and then rebuild it into a tracked vehicle. I was thinking about using tracks from a BV-206...

I'm getting ready to powder coat the frame on my Max IV. I had it sandblasted prior to working on it and I'll sandblast the surface rust off it it...

Does anyone have any experience having parts powder coated? On every project that I've ever done, the worst problem was the low quality and quick...