Search:

Yup, it's cool. There's already a thread here about it: http://www.6x6world.com/forums/other-aatvs/28810-rip-saw-3-0-a.html

And, another with the same builders:...

That's CLASSIC!! :rofl:

My Max II has a Vanguard 20, and it'll go straight up a sand dune. 4 strokes have low end torque that doesn't exist in the "ring ding ding" 2 strokes. They have to run full tilt Bozo RPM to get...

Sounds like the tire's shifting around the wheel. Tubeless, the bead breaks and it's pffffffffft. With a tube installed, the same problem angles the valve stem in the wheel hole until it rips away...

That would be my question: is the solenoid clicking? If it isn't, you may have an intermittent ignition switch.

I actually think it's the solenoid, and low temps are putting it into a bind from...

The 9 watt LED's are about the same as stock. And, like the stock lights, they're o...kay. The good part is the very low current draw. I use them when running dunes alongside quads etc. for extra...

53 in eastern Washington state. My Max II might as well be the Moon Mobile here, you could probably could the 6x6's in this end of the country on the fingers of one hand.

Depending on what lights you have, here's a couple options.

The round PAR 36 type bulbs, such as the 35 watt GE 4414 can be replaced by one of these:

Good 'n' bright, but about $60 each. Par 36...

I haven't been in water yet, but I did a few hours in the sand. I got a "real" gauge from eBay, and discovered my cheap stick type 1-20 PSI gauge was worthless. What I thought was 2 PSI was really 6,...

I think the fact that they were using crowd funding sums it up. What they should have had, was a Hydratrek or other more capable machine. MPAV AMPHIBIOUS VEHICLE (i.e. expensive!) Like I said before,...

"Sadly Argo engines don’t take too kindly to being submerged… the ships engineers are still working on it and not very optimistic about its prospects"

So, only Argo engines fail when submerged?!?...

Forget diff lockers. My 1967 Chevy truck has a locker, and when I get hard on that hot 327, it'll almost skid itself straight. My Jeeps past and current that have them make turning on snow more...

I just found this thread. NICE machine!

As for water speed, you're going to find that 5 ~ 6 MPH is going to be a "brick wall" for maximum speed. You're dealing with a displacement hull, much like...

What? I'm the only one with a camera?!?

Come on, we need PHOTOS!

Thanks.

One each, scrap piece of 1/16" thick aluminum sheet, cut to fit the original dash area.
WW II surplus Dialight "push to test" indicator, Ace round key on/off switch, 4 military surplus...

Not a bad idea about the boat thing. That should confuse issues in a court of law. I've thought about should I ever get hassled about somewhere there's an NO ATV sign. Hey, it's a AATV, it's not an...

It's the same way here, in Eastern Washington. I take my Max II out into an area full of sand dunes, and I might as well be in the moon mobile. It's like showing up to a sheriff's posse riding an...

That's what's great about LED's, I can turn on EVERY light, and it's just about the same amount of power the original "hot wire" bulb lights used. I can't even see the amp gauge needle move when I...

GPS receiver, a "meep-meep" horn, a set of convex mirrors, a 30 inch LED light bar, (Which lights up, no kidding, a half mile of terrain) rear floodlight, marine navigation lights, halon fire...

Got mine from eBay. LED 9W PAR36 12V AV DC High Power Lamp Bulb 5050 LED 800LM WW | eBay

It's about $50 for a pair, but they're pretty much "heirloom" bulbs. What's nice is the low current draw,...