I wonder if they would give out that info ? Thanks
Type: Posts; User: doccerny
I wonder if they would give out that info ? Thanks
Does anyone know what hydrostatic pump they are putting in the Mudd ox 8x8.
And hydro motors.
Could be could be. The world may never know. Seems like I've talked to the world and it's all a guess. I've built the beast now can't control it..lol
Thanks...I'll decide what I'm gunna do and let you know. Good luck huntin
IMG_20141029_214103_338 - Amphibious ATV Pictures This is not the best pic all I had....taken couple years ago before it was done.
I'll try to find a pic of the tranny set up. Thanks
I haven't found out what calipers will fit yet...hope to tomorrow. But I'm sure I'll have to build mounting brackets. The tranny pan or mount is still there but I'm sure the mech. Brake mounts would...
Yip it's chain driven off the cycle tranny. It is sprocketed down about 30% at the transmission imput. Then sprocketed down again from the output to axel about 40%.I do have hi and low range on the...
Thanks Jim....leaning toward hydraulic brakes. I have new rotors ( thicker) I'll look for some calipers to fit.
I've got 22's on it. The mass of the load is well centered so balance loaded is as it good as it gets. Like to know what the difference in brake pressures are between mechanical and hydraulic. You...
Good thoughts...I already put the new tires in the middle (a little taller)...nothing. last year we removed the front chains so pulling on the back 6...very little improvement. Thought about pullin...
I agree with ya on the tires...they are Kenda Bear Claw. But I'm not trying to turn sharp at all...just slow elephant turns. It rolls thru all breaking except at high speeds. The mechanical breaks...
I've got a Suzuki gs500 engine in it with 6 gears it will get low. It needs hydraulic breaks but would like a beefy er transmission ...afraid of shelling it.
Have shop built 8x8 with old argo transmission in it.Built this one from ground up.Have used it for 2 years with no problems but doesn't turn worth a flip at low speeds.Problem is weight we know.This...
You can get coil pins at WW graingers.com I bought some,you can get them in many lengths, and also in different rockwell hardness. They come in bulk packages too( like up to 24 count). I've had them...
Well talked to my machinest buddy and he made them out of 4140 heat treated,so I guess their just too small dia.and I'll have to beaf them up to 1 3/8" or 1 1/2"this summer. Whipper would you spline...
Thanks Whipper, I,m replacing the 1" dia. original shafts, one at a time. Until Sat. and A one month old new shaft broke. Don't know where it broke yet haven't tore it apart. My buddy is a machinist,...
Yip, I've seen and read alot about Whipper on here he is the guru. I snapped another back axle the other day and it was new ( month old). My Argo doesnt even look like an Argo anymore. We use it as a...
Thank all of you,I'll ponder it around with my buddy the machinest.
I'm like you, I got to trust someone when they go to spitting out numbers. Too bad they aren't in grades like bolts. LOL