Hey Rob, hope all is well.
If you haven’t pulled this apart yet, there are front rear adjustments on the uprights through the frame rails and sideward adjustments under the engine. If you have,...
Type: Posts; User: ARGOJIM
Hey Rob, hope all is well.
If you haven’t pulled this apart yet, there are front rear adjustments on the uprights through the frame rails and sideward adjustments under the engine. If you have,...
Should have come to Busco, you would have been happy with conditions.
Great to see everyone again, great riding especially Wednesday and Thursday.
1) ArgoJim with something Amphibious that runs
2)
3)
4)
5)
3/16 by 1” maybe? Contact Max direct if no other replies.
Yes I believe from regulator plug to harness to ammeter to switch back to battery, there is probably only 1 big and 1 small to battery with no other accessories, ground may have 2 as well.
However...
Looks like I’m flyin solo, better not here no s@&$ like last time I was solo.
You may want to try Dave Phelps.
Most Max and Argo have a fuse in-line of the charging wire, however, are you certain you hooked up every wire you disconnected to hook up the battery.
Email me pictures, let me see what you have.
I have a similar kit I never really looked at but not factory, I would imagine the outer plate was made that way as many newer winches like Warn come with the fairlead mount in the kit.
Yes I dropped the 34 tooth to 28, 30 would probably be a good 4stroke trail friendly gear, the 34 were used til the end of Max including the splined units which I would assume for track use reasons,...
Like these guys wrote, will depend on load and terrain, rubber tracks may require low more than super tracks.
That's an interesting shaft extension unless its a tool, maybe smudvapor or Don? Scott has the last one I had.
You will be fine but may have to loose a link or so. I put 28's in my racer for short tracks but we don't do them anymore so I have to go down more for the big tracks.
If your not there yet, no scramble as far as I know, but yes this weekend is the outing.
The upper bolts are forward and the lower bolts are reverse. But tighten them evenly when possible. You want to keep the u channels or popsicles vertical when in neutral, do not over tighten or the...
Littleg
Key switch failing?
Glad you guys had a good time, hopefully the 2nd part is good