Search:

msa

You bet. Make everything simple to fab using run of the mill machines. As far the bands, I have spoken to a company that applies the very high end brake pad materials to race pads. Cant use...

Gents,

Good points. This design utilizes gear dogs for engagement and is heavier in design. It takes after drag bike engines and trannys that are extremely tough. I am currently designing a new...

15665

Agreed. I plan to use a keyed or splined sprocket.

Yep. The engine and drives are for representation only. That shaft would need to be supporting by a bearing certainly. Since the acquisition of Recreatives and the subsequent business problems of...

Hello Folks,

I have completed the preliminary design for a new T-20 tranny that is more robust, easier for the layman machinist to manufacture and should be downright bulletproof. I have completed...

All

I am working on the final design of a sprung 6x6 ATV. You can see it on Grabcad under Cadman. I have the funding for the prototypes but am still looking for a good commercial drive solution. ...

Garrett

Do you have pics. I have a 900 that could use some new tubs?

Is it worth adding a hi/lo gearbox?

All,

After a complete restore of 950 with a 16hp cast Kohler I will now embark on the next adventure with my 950 that incorporates an aluminum chassis and springer design (tangent from my previous...

All,

Quick question on the t-20 behavior.

I have restored my Hustler 950 to functional and working good mechanically. However, I now realize that I get a jerky and sometimes surging behavior...

98379838bugeyed

starting my build soon. design work is done.

Sneaking up on the final design. Looking good so far.

Updated wheel assembly that uses two lighter shocks - final

I think this would be a good lower cost solution for a 980 tub springer conversion.

Will verify dimensions for anyone interested.

In addition,

I also have thermal forming experience and know how to make large vacuum rigs. Do any of the members have a large oven for powder coating or painting cure?

cadman

All,

I can reverse engineer the forms design. The question that comes to mind is what is the cost for machining a new form from cherry wood and finding the company that did or can do the forming....

A shot of the suspension mounting plate.

Complete unit finalized. Time to build.

Kunzmm

Got the quote back from the plasma guy. The quote was less than $1k including the steel to precision plasma cut all my metal pieces for my build including all the panels, tabs, lugs, and...

Kunzmm

Thanks for the help. Decided to go CV due to this Front GM Chevy Driver Side CV Axle Half Shaft Complete Hub Bearing Assembly | eBay. Complete CV shaft and hub for $66 ea.

Look this...