Search:

1757917580

Ok. Please talk real slow. I have labeled the wires by number and the point of attachments with letters. I do understand that the large red cables attach to opposite lugs on the...

Sorry for the long delay. Thanks for the response. I am going to post some pics because Im reeaaal slow. Thanks again

Ok, so i pulled the battery, removed old solenoid and slept sometime after. I have an off the shelf lawn tractor solenoid and now I cant remember what wire goes where. The wiring diagrams in the...

Check out what I did. http://www.6x6world.com/forums/max-atvs/36225-max-iv-drain-plug-solution.html Dont know if argo plugs have the backing plate I made. They look similar.

Any before and after shots?

Awesome! That is my goal for my Max IV. I will be buggin you when I get going.

You have done what I plan on doing to my Max IV. Looking forward and not looking forward. Where did you buy your chain, bearings etc?

The plug base actually is flush with the reinforcement poly. The thumb tab on the plug itself is about a half inch. That is the part that would be susceptible. Time will tell! There is a brass plug...

Thanks Mark. Hopefully it is water tight and the plastic fittings hold up.

Well i turned my attention to the drain plugs when i had water in the tub and the setup i had was a pain in the a$& to open to drain. I wanted something i could open without tools.
When i...

Im on it. Thank you sir!

Thank you sir. Im on it!

Well i finally had some time to try and get things sorted. As per guidance, i pulled the battery and charged fully. I reinstalled and while in there noticed a dangling fuse holder end with no fuse....

Ill charge up the battery and check the voltage. Tried checking yesterday only to find out my Craftsmen voltmeter was reading increasing voltage without touching anything. This may be an electric...

Thanks. No more solar charger then

1992 Max IV 16 hp Briggs.
Well i think my fuel issue is resolved. Mostly centered around stupidity. Choke was not being fully disengaged and my mistrust of the fuel shutoff I installed caused me to...

10-4. Still interested in updates on performance or any issues. It is one of those deals that is hard to pass up! Thanks

Pardon the ignorance. Why cant you cut the exhaust manifolds equidistance and flip the exhaust upside down. Then weld the tubes back together? Can you just flip the exhaust without cutting? Ive been...

Im seriously considering one for my Max IV. Im very curious how yours does. Please keep us posted. Thanks

Sorry sir havent visited in a while. Used iron pipe, straps from home depot and brake bands from Northern tool. Like everyone warned, they pretty much sucked! Be glad to send more detailed picks if...