Search:

Any update on that belt?

I've seen it on axles and jack shafts. Have the axles repaired at a machine shop by welding and then turning on a lathe.

That is a tough comparison. Argo has multiple 8x8 models so we would need to know the specific model and year. And then the transmission letter for the Argo. If you narrow it down some maybe you...

It is like a big zip tie, push down on the upper block and pull up on the ties. Cut off the excess while leaving some to grab onto for adjusting later. I saw another design where a person uses two...

http://i73.photobucket.com/albums/i233/jerrynuss/Max%20Amphibious%20ATVs/28tz1tw.jpg

I found a link:

Chain Tensioners

Don,
I don't think it would have to be very tight. Remember the older Argo style that used a couple of coil springs that pulled two sliders together. It was mounted but these could float on the...

I've been asked how the Hustler swims and how well the 18 hp engine moves it. It does very well especially for a 23 year old original motor. I have not found it to be any less stable than any...

They look easy to make with a couple pieces of angle iron, plastic from a cutting board and a couple of bolts and nuts. Just notch the plastic so they stay in the groove. They would not need to be...

Hustler out in the back yard.

Untitled on Vimeo

I believe they were or they are 22" and they had just had a set of 25" on it. This is a factory test machine. The plastic bag is covering a data gathering device. The two holes on the right side...

A few pics of a Hoot:

http://i73.photobucket.com/albums/i233/jerrynuss/Max%20Amphibious%20ATVs/PICT2086.jpg

http://i73.photobucket.com/albums/i233/jerrynuss/Max%20Amphibious%20ATVs/PICT2087.jpg...

The description sounds like this:

http://i73.photobucket.com/albums/i233/jerrynuss/Max%20Amphibious%20ATVs/5973kc1l.gif

several vids on youtube of 6x6 machines and quads running the same trails. If a quad can go through a 6x6 can. What stops me is the super soft silt mud that is just thick enough to hold the...

George gave you a good answer. The lower body or tub is a displacement hull. The buoyancy is related to the displacement of water. If the weight of the water displaced is greater than the weight...

I snapped a couple of pics of the 980 the other day when I was out training. It is one of my favories AATVs.

http://i73.photobucket.com/albums/i233/jerrynuss/Max%20Amphibious%20ATVs/IMG_0048.jpg...

I'll measure mine tomorrow. It is sort of hard to get off with the exhaust going out the side and the clutch is very close to the tub.

I'm wanting to change the tensioners and I have a 950 to...

It is geared low at the axles, you could swap out the sprockets from a 950 and get more speed.

I think that truck belt may be a serpentine belt. There is a belt that will fit but the engine needs to be moved back just one inch for it to give a good fit.

Salisbury 704084 is the correct...

I can't find that in a cross reference how did you do it?