Search:

I need at least 2 right side ASX 26-1300-12. Will buy 3 if they are new
Thanks!

30-50 hrs if I had to guess. Not sure what napa would have. (Better quality)

I have a Hustler 980. Built 1 1/4" splined axels that are 3 inches longer than stock. My outer bearings are going bad in a very short amount of time. I do understand the added stress that longer...

What is a pop sickle stick T20
I'm looking for a T20 transmission for my hustler.
Could you please call me
832-562-1721

Thanks for the reply Adreneline junkie! It doesn't backfire and idles fine. It's just very hard to start when it's hot. It seems to have gotten worst over time. As I try to restart the motor it also...

It is carbureted. The year of engine I'm not sure about. It does have a new carb. It's only hard to start when it's been running for about 20min and beyond. Once it cools down wether it's a couple of...

Kohler 26hp starts great when cold. Then becomes hard to start when it is at running temp. It takes a little longer to fire causing fuel to also load up then blowing black smoke when engine turns...

I would love to get a hold of 3 hustler decals. Could any of you guys help me??

Dan67 would you like to sell the 980 tub?

Does anyone have a recommendation on what style clutch I should run?

I have a 1 1/8 now. I'm thinking about putting in a 30hp crank and push rods. So I can go 1" or 1 1/8.

I have a hustler 980 Bigfoot that I am installing a 26hp Kohler. What kind of clutch should I use to get the maximum performance out of it?

Thank you guys for the feed back! I'm going to tear down anyway and replace can and rods for more horse power. I'll just go ahead a replace rings while I'm there. Thanks again for the feed back!

Does anyone know what the lbs should be on a compression test for a CH26? Bought a used Kohler with 1800 hrs on it and wanting to know if the valves and rings are still good.
Thanks

Mike how do. Change the title to my classified?
It needs to say:
6 26x13-12 ASX Vampires forsale w/whls