Anyone have a part number or happen to know where it is and what it looks like?
Type: Posts; User: KevinW
Anyone have a part number or happen to know where it is and what it looks like?
If it isn't an exhaust leak, you get everything sealed up and it's still getting into the cab a smoke machine will show you where.
If it isn't leaking in through the engine compartment I would try adhesive foam between the snaps and anywhere else you see daylight.
As a last resort you could divert the exhaust pipe just for the...
Replace the drain plug with a drain valve and a length of plastic tubing that will run out the rear drain hole in the body.
https://youtu.be/2-95koBYpjo
Your voltage regulator should produce at least 14vdc when rpms are high.
Does the limit cap on the idle screw slide off or do you break it off?
Conquest, Kawasaki 620D
Thanks.
What viscosity of oil are you using?
I can't suggest a motor replacement but I would look at the piston and cylinder,
If they look good, I'd be putting new rings in it.
If the piston and/or the cylinder is bad then I would be...
Thanks for that idea.
Checked that and they are about half the size and still intact.
Not sure what "sticks" are?
Steering lever?
Checked and there are two, one on each steering lever.
Ok thank you all, TDC using the dowel and watching the valves move into the compression stroke where there was very slight play in both rockers I adjusted them to .009".
That should be the end of...
I pulled both intake and exhaust rods and they are both clean.
Not sure about the valve adjustment.
The intake valve now with the rocker loose is measuring .028", that's the most clearance I can...
Thank you for responding.
I am just trying to find TDC for a valve adjustment.
The #2 cylinder in the rear is fouling the plug with dry carbon deposits.
I wanted to check the valves, Kawasaki...
Can someone try to explain where I might find these marks on my Conquest?
I had the same problem with stale fuel.
Is the fuel fresh?
All I've been doing is lubricating with silicone and I haven't experienced any problems yet.
Thanks for responding.
Hello;
My manual suggests a complete service of the clutch at 250 hours.
What is the complete service they are calling for?
Thanks.
Sault Ste. Marie, Argo Conquest 6x6.