Forum: Max ATVs

Hey could one of you guy's with an i/c flat twin in a max2 please tell me what size belt you are using. I don't have the original belt and would...

I just picked up a 97 Max IV with a Kohler CH20 engine. I have searched the net and here and have still not found a manual for this puppy. I...

Hi, For two year my Max IV has run perfectly. I've never had any problems with it or had to work on it. Now when I drive it, it starts...

Can anyone provide me with the basic measurements for the factory Max IV windshield (outside edge to outside edge)? Thanks, in advamce. Uncle Vin

hi folks,...newbie here.....you folks are the best ! :adore: after reading many posts,I think I am sold on a MAX IV...but I have some questions...

I am in the process of installing a bilge pump in my Max IV I was planning on installing a marine Thru-Hull fitting in the rear. I would prefer not...

when i am going forward and start to pull my right lateral back slightly, my tranny starts to make a clatter sound . not sure if this could be an...

Is it a Maxargo or Argomax?

Is there a way to heat the cab on a MaxII or IV? Is there an option to put in a windshield wiper? Thanks

was thinking of making a red-neck snowplow for my max IV, and was wondering if i will need to go to tracks or has someone tried this idea using just...

my max reverses great on the right side but its pretty weak on the left side. i know it is the t-20 adjustments have to be out, but what i need to...

Does anyone know what year they went to splined axles. Need to replace one and not sure if it is round or splined. My Max II is 50 miles from here or...

I just got back from pulling and winching a snowmobile a 1/4 mile out of the woods. I Love the Max because It did it (I only winched twice... without...

As I'm sure you Max owners know, in 1996 the IV model bearings were different sizes for the inner and outer. I've replaced one axle set of bearings...

I was going to replace the Wheel bearings in my Max 4, Tell I came up with a fix. I first clean all the dirt off the bearing and axles. Then in the...

Hey can someone tell me what the factory used to install your windshield on a maxII I bought one but don't know if I should use rivets,bolts or...

I recently picked up a MAX II & when i bought it, the owner gave me some drain plugs in a ziplock bag.. I cannot figure out for the life of me where...

Loving my new to me Buffalo. 2 weeks ago I installed a new set of 27 inch Swamp Fox tires. It climbs VERY well, doesn't swim at all now. I towed a...