Forum: Max ATVs

I want to register my AATV for a boat licence and I need to find the VIN Number. Does any one know where it is stamped? I have looked it over and the...

i was wondering how much just the roll cage u guys have on the max iv's weight. and if you notice a difference in your performance with a rollcage...

Is there a weight distribution problem with a rear mounted fuel tank? In my Max II rebuild, I need to replace the front fuel tank due to rust....

my body on my max II has a hole in the side of it where the previous owner cut for a muffler but is in the water line......and one tire rubbed...

i was wondering what is the normal maintaince on a max iv aatv. i know to keep the chains lubed and tight but what else should i do. it is a 98...

Hey, does anyone have the link for Recreative Industries? Can it be made sticky please? Thanks.

I would like to fabricate a winch mount for my Max II does anyone have a photo they can share?

Hi: I am getting mentally prepared for the task of installing the tracks on my Max II.I bought an '03 slightly used in the spring.It came with the...

Hello All I've been reading this forum for a year or more but up until now haven't posted anything. Well, here I go. I just ordered a new Max II...

Hey guys, any idea why my MaxII pops and jumps when I pull one stick left or right to turn? It seems like the chains are out of kilter or something.

I am new to this Max II, Just finished installing a new front axle and bearings. Put the machine together today and in would not do anything when...

I have the front mount fabricated on my Max II, and a trolling motor will be in my hands next week. How have you guys wired the trolling motor? I...

I have the engine and t20 out of my MaxIV. Is there anything that I should do now that the guts are out?

Pulled the max out of the garage today, and noticed that it was kind of hard to shift from forward to reverse. Ran it about 8-10 miles down the...

I took my Max IV with tracks out in the snow for the first time and was very disappointed how it preformed. I'm afraid I will be digging it out more...

What is the proper method of jacking up the wheels off the ground On a Max IV without damaging the body?:dontknow: I need to properly check chain...

Will argo tracks fit on a 03 max 2 and do i need extensions, and does a 18hrs briggs have enough snort to push them :dontknow: thanks

I have a MAXIV with 27hp liquid,and built up solidaxles with machined inverted cones for added strength. I want to put 11/4 inch paddle snowmobile...