Forum: Max ATVs

Just woundering how long does the 530 chain last on t20 box to sprocket then sprocket to wheel sprocket I have found that the left side driving max...

Hi guys, just curious how wide the seat is for the Max II's? Thanks

I just recently purchased a Max IV and it ran great but I let a friends son take it for a ride but the next day I found that it would not turn to the...

Ok, here's the scenario: I am trying to remove the tire on my Max II, I removed all the lugnuts & for some reason the rim just does not want to...

I am thinking about putting a 20 horsepower Onan motor into my max2. right now it's in my 95 Toro garden tractor. It got about 450 hours on it. it...

i found a 22hp koler engine from a garden tractor, shaft comes out the front on the tractor so i assume it horizontal shaft. will this work in a max...

I own a max11 23hp kolar can anybody tell me how a set of tracks would work on sand dunes as I do a lot of driving to surf beachs there are a couple...

I have a 98 max 2 and was looking to replace the chain since its still the original and is pretty stretched. How much #50 do i need to do just on...

Could anyone suggest to me a quality replacement bearing ( part # )for a 94 Max IV. rear axel (splined) I don't know what size the axel is. Are the...

well i just got a basket case max II it came wiht a 12hp kohler in which i am sure isn't big enough for me. what i have found is a 340cc yamaha...

I noticed that whenever I grease my bearings that it just oozes out the top. This doesn't seem right to me...What should I do to try and fix?

Just purchased a Max IV and went out today with my 5 year old daughter who had a blast. I have a few questions, does the gas tank vent through the...

I was rebuilding this Max IV that I picked up out of Atlanta last year thanks to a hot tip from jpswift1. Jennifer decided that it was the one that...

I have a neighbors max 6x6 and it has a couple problems. First off it runs, seems to run fine, but it wont shut off.. im assuming maybe the ground...

I'm looking at buying a good used max 2 but it only has the 16 horse v twin that seems pretty small to me. i'm concerned about running out of power...

Can anyone offer some advice on an older model max II chain tensioners? The original ones dont seem to hold worth a dang! Should I go with the...

Hi I was wondering if someone could tell me what size drive belt I should use on my RIM with the g50b engine. Thanks

Hi All, i'm changing the front bearings on my 2003 Max IV. All is well but the inside bearing...instead of the usual locking collar I'm used to (one...