Does any one have any pictures of the upgrade kit? My Max has thru holes it does not have slotted holes and it has bolted on front brackets. From the description It sounds like my Max already has...
Type: Posts; User: turtle racer
Does any one have any pictures of the upgrade kit? My Max has thru holes it does not have slotted holes and it has bolted on front brackets. From the description It sounds like my Max already has...
Has anyone had this happen to them? Is there a solution to prevent this from happening again? Yesterday my son and I started doing some basic maintenance on our 2002 Max 4. We discovered the lower...
Seems to be a common problem. See the 11/21/2009 post. http://www.6x6world.com/forums/max-atvs/9744-max-iv-left-steering-rod-very-tight-all-sudden.html
I had the same problem. It was just as Robinhood02 described. I had to pound on the steering handel to get it off the tube, but once it was cleaned and greased it was fine.
Did you paint your engine stand? When I painted my MAX I was not getting a good ground from the engine to the frame to the battery. Try running a temporary ground the engine (clean the engine...
I'm new to these weird 6 wheeled things, I have my Max IV apart for restoration and I have a question.
Should the steering levers slide off of the bar that they are attached to?
The left side...
Instead of putting hinges on my seats I'm going to notch a couple of pieces of angle so that they will hook under the rear seat frame support then I'll screw them to the bottom rear of the seat...
My Max has the 25hp kohler.
Thank you for the info. I am sure to have more questions as I go. The Max IV frame and other parts should be back from powder coat in 2 weeks. These buggies are expensive, motorcycle times 3 for...
Thanks for the info thus far.
Does anyone know if I press off only the dome cover or that side of the pulley and the cover?
Thank You
It's the engine clutch pully. It appears to be a model 1190 it has three nuts on bolts, that lock in place with either cotterpins or lockwirer, around the bolt the holdes the clutch to the engin...
Can some one assist me with how to disassemble the drive clutch/pulley from my Max IV 900T. The clutch is removed from the engine. I appears to be a model 1190. I want to dissemble, inspect,...
This is my story of misery and future redemption, I hope.
I bough a 2003 Max IV 900T about a month ago. It ran and drove, but needed work, the guy I bought it from was up front about what it...