Look for jpn_dadms
Type: Posts; User: ganding
Look for jpn_dadms
Well I can’t get pics to load I’ll post a link to instagram and maybe y’all can see there
What?s up folks been quite a while since I?ve been around. Pulled the hustler out of the weeds today and the frame is on sawhorses for a fresh rebuild. I?ll throw some pics up tomorrow y?all be good
can any of you gentlemen be able to give me a tooth count on the center sprocket I need to replace mine and I'm not using richards relics
do any onf you gentlemen know the length of a 945hk axle ?
JP I sent you a message give me a holler when you get a chance bro thanks
garret
drew do you still have a rebuilt t-20 laying around ?
I'm running a 1 1/8 comet 94 c on my kohler magnum 20 I'll let you know how it runs when I get in from offshore
would it be too much to ask to see some more pictures of the external frame ??
not quite I have been out in west texas working. I should be home in a week or so and have some time off where I can get back on it.
what kind of clutch works on a 1 1/8th shaft ? bought another hustler 945HK and I have a spare 18 horse Kholer Command motor in the shop
I was running a 16 hp Kohler k 341 but that was a little underpowered so I stuffed a polaris 425 magnum in it should be done with the install when I get back from offshore
ok guys I got my hustler running and moving finally now here is the monkey wrench. I acquired a polaris 425 magnum engine wiring harness and accessories......thinking about making the swap pros ...
I shall call this OMEGA because this is the end game for hustlers in my book
this is my thoughts after talking to some folks last night I can run the 4x110mm front rims which are 8" wide roughly and I will have no problem with rubbing on the tub granted my foot print will be...
yes sir I am planning to run 25x11x10 mud lights if my math is right there should be 6.325 side wall cushion with 3 psi as far as beadlocks I am going to be doing some chin scratching on this one but...
I wanted to hear everyone thoughts on running 10" wheels on my 945hk I am removing the hubs with the 5x4.5 bolt pattern and installing 4x110mm hubs all the way around so I can use more common atv...
would it be possible to post a couple of pictures from the side with the tires off I am really interested in seeing how all this engineered. thanks
hammer thumb
man where can I find the schematics for the external frame I could make my 945 a monster with that
1. fmints, 1984, 980 Tall, Bigfoot
2. jpswift1, 1984, 980 short, Bigfoot
3 & 4. wildtexasranger, 980 tall, Bigfoot
5. Stonewall, 1983, 945-HK
6. cfherrman, 1976, 950 /w JLO 440
7. Micmac, 1970s,...