If you are looking to seal between the outer axle bearing flanges and tub, you can use silicone. I'm sure cork gaskets are available somewhere....maybe a farm store/dealership, but the silicone...
Type: Posts; User: thebuggyman1
If you are looking to seal between the outer axle bearing flanges and tub, you can use silicone. I'm sure cork gaskets are available somewhere....maybe a farm store/dealership, but the silicone...
The epoxy holds up very well, just remember to follow all mfgr recomendations on prep. Clean, scratch, alcohol clean and flame treat prior to application and it will adhere well. Every material...
The older brittle bodies are ABS and can be repaired with ABS melted into a goo with acetone and reinforced with cloth.....Or with special epoxy, and cloth makes that easier too.
The HDPE (high...
A stock MaxII has 25" center to center on the axles. Some people have found 25" tires for 9" rims that run small and re-molded the tub above the tires to avoid scrubbing. You can find larger tires...
I could not expand the picture. I think there are different variations of the shaft.....I have one ( not sure which one ) but I can try to bring it to Ash in a couple weeks.
This version was much easier to fabricate but far less convenient to use.http://www.6x6world.com/gallery/data/1053/thumbs/IMG_02671.JPG
I've put them beside the seat (single seat) and on the floor in front of the sticks. On the floor foot operated is by far the best. I've since added traction bars to the foot pedals because mud...
Just use 4 pieces of unistut.....and a couple of spacers to eliminate the crappy rubber mounts.
Is the surface scarred up? if so, they can usually be turned down. I've done it several times as long as the damage isn't too severe.
Too tight is better! In reality it is only too tight if the machine runs away at idle or shifting is impossible. Is your alignment correct? Is this a new belt? 1 3/16" wide? Where is...
I've been trying Dave......Just plain old too busy. I got laid off last Friday, so I finally get a break. I think I've put in a years worth of hours just over the summer and I'm getting too old...
It is doubtfull that is your problem. I'd try: If your battery goes dead in a specific amount of time (say 1 week), try unhooking the cables from your battery and wait that same week before...
I'm planning on being there Thursday mid-afternoon
Please post some pictures
How about if I save you $100
https://www.mfgsupply.com/atv/atvclutch/atvclutchrec/300782a.html
2017 chevy crew cab short box I love the 6.2 engine, 420 some horses and better gas mileage than the 5.3 Best mileage I've gotten so far is 26.6 mpg (50 mile average), typical is approx 22mpg....
Parking it in fwd will not hold it. Parking in rev. may, but still not a good idea. I have used a tree before, just drive uphill of the tree and let the machine roll backwards into it. Parking...
That clutch has the stock Max spring (green or equivalent). The red spring is stiffer making the upshift slower....this is for more power from smaller motors.
You will have to see what is wrong with it first. Muddox is the source for parts, but I doubt you need anything but a seal kit and maybe bands while you have it apart.
The clutch key is a half...
https://www.mfgsupply.com/300782a.html