Thanks
Type: Posts; User: wiggy
Thanks
Hi
Yes key was ok
Is that the head gasket blown??
Thanks just checked how tight the head bolts are and was not that tight , oil coming from the top gasket , when you remove the oil dip stick it’s like a steam train same coming out of the air filter
Reconnected the black wire and still have a good spark , still will not fire up , even with a bit of petrol in the plug hole, and then I get a bit of white smoke from the exhaust and coming out of...
Taken the black wire from middle of the coil and have a spark now, but not tried to start it yet
Hi
Thanks for reply
I have two small wire both black plus hot lead , one come from middle of the coil ( spade connector )and the other comes from anther type of coil ( copper wire ) that is also...
Hi guys
I just bought a 2nd hand MTD Sprinto garden Ride on mower , needed a starter , now fixed but can’t get it to run or even fire even with fuel in the plug hole , checked and the safety...
Hi guys
I have filled till it nearly comes out of the fill port.
Yes the engine runs ok till I remove the screw in the tube then it dies , not sure how to attach a picture on here
Hi
Looking at the engine with the drive shaft in front of you , the yellow plug ( says fill oil ) is on the right at the base near the drain plug , but I have another on the left higher up we’re...
Hi Guys
I just bought my son a buggy and has the Briggs & Stratton intek IC 305 10 HP engine fitted. ( buggy is a bocart 2001)
Engine numbers
Model 205432
Type 0164E1
Code 001221YD
I...
Thanks guys
My first front axle years ago was a pig
But recently done the back axles went ok just the middle ones I was thinking omg lol
Hi guys
I have now finished one Max 2 and started my sons one, but noticed slight play in the middle axle bearing:help::confused: I have done the front ones and back ones before but not the middle ,...
Sorted jet blocked thanks for your help guys
Hi guys
Just cleaning the card, taken the top of the carb off and look green - blue fuel, been parked up for a bit this one, how the heck do you get at that 2nd bolt at the base of the carb? 🥺do you...
Thanks guys
Yes poor me in the dam uk ☹️
Hi guys
I am looking at making a winch mounting bracket for my max II ,what thickness of steel plate would you use? 5mm?
Thanks Richie
Thanks guys, I thought it must be, just never done a Briggs carb, was running fine till parked up for a long while due to house move and lots of diy thanks again
Hi guys
Finally got to to work on my maxII , it starts ok, ticks over ok , but when Erving up it dies, but will rev up with choke on🤔any ideas , one of the jets blocked?
And does anyone have a...
I hade the same problem a couple of years ago, could not get the set screw out, ended up cutting it off
Got new brake disc.
I nearly had the same problem on a rear axle, the set screws on the...