Search:

I've been running the factory rubber tracks for the last 2 years without the front drive chains with no slippage issues. My tires are the chevron style which may account for that.

I hope it goes smoother in PA than it did for me in Ohio. They were determined to register it as a 24 hp inboard boat which would have keep me off of many of the small lakes with a 10hp limit. Took...

Installed that kit last year on my MaxIV. Well worth it.

On my 2000 MaxIV, there is a hatch on the table for the passenger side diamond shifter to be removed. On the left side (drivers side) I used and engine lift and unbolted the table legs to get an...

PapaTim, I got my plow and cab from these guys in Ohio: ATV Trailers | Off-road Trailers, Carts and Wagons - Made in The USA by Country ATV. but I see they no longer have the fabric cabs.

I bought a plow and rails from ATV Trailers | Off-road Trailers, Carts and Wagons - Made in The USA by Country ATV. a few years back and it works very well. The deepest snow I have pushed with it is...

I switched all my small air-cooled engines over to Mobil 1 after they get broke in. Seems to roll over faster in cold weather and lasts longer than conventional oil.

I had a throttle cable snap a couple of years ago and couldn't get a replacement. If the outer shielding is still good, take a piece of the broken cable to a hardware store and buy a length of...

I have the same tracks as you do, for snow, they work very well. Thick mud not so well. Water use- forget it.

They are very few and far between here in Central Ohio. I had a MaxII back in the 80's which was great until it was vandalized to the point of non-repairable, then went without until I picked up a...

For the windshield I bought one from CountryATV a few years ago that was made of Lexan and it has heldup very well. Unfortunately they stopped making them last year. I don't know if anyone has put a...

Outstanding job on the power angle!

I use my Max IV on the local lake quite a bit for fishing. I use a trolling motor on the front and have added a couple of foam floats to the front under the winch mount to keep the front more stable....

I tried that ONCE, didn't work for me. I ended up sucking all the air out of the tires with a shop vac to re-install them with the tracks.

I got into using Fluid Film about 2 years ago and now use it at the farm on anything I don't want to rust. Plow surfaces, disk, we even undercoat our trucks with it before winter. Great stuff. Lasts...

You might want to try these folks ATV Trailers : off-road ATV Trailers, carts, ATV wagons, equipment and accessories - Made in The USA by Country ATV. They make accessories for the MaxIV units. Good...

Good post and it sure got me thinking about adding an extinguisher on mine.

I had the same thing happen to me with the interior steel cable broke. I went to the local Lowes with a piece of the cable and matched it pretty close. Been going 2 years on it. Just slide it through...

The fellows at CMI are always improving on their product line. I have had good luck with their attachments, but the plow is a little light-duty for heavy snow plowing. I haven't bent mine yet, but I...

56, just north of Mount Vernon Ohio. My grandkids love to ride with me!