what is the engine doing? is it hunting (going up and down ) if so I would recommend cleaning the carburetor.
Type: Posts; User: motor head
what is the engine doing? is it hunting (going up and down ) if so I would recommend cleaning the carburetor.
Also I have the sticks adjusted so they don't interfere with installing the floor board.
I test drove my Max 2 after my tranny rebuild and the bands worked good I might have to adjust them a bit but not sure i want to put some more time on and check for leaks at the plungers cause that's...
I haven't started the machine that's coming in the next couple days, but i had to adjust the bolts out to get some travel on the sticks and that put some slop in the travel.
Somebody wrote about the bolts on the band clevis's being too short after replacing the bands in the t20 tranny, well i came across the same issue when i rebuilt my tranny. Before I installed the new...
I got some good measurements with a dial bore gauge and came up with 1 to 11/2 thousands clearance which should be fine.
That's good to know Thank you.
Thanks DanW, I reposted this under carrier drum and am doing some more measuring to get a good number and if that is what it turns out to be then I will go with it if not then I need to get new...
The carrier drum is the one I'm looking for info on, I did measure the center plate shaft and the bushing in the carrier drum with calipers and came up with 1 to 1.5 thousands clearance, but I feel I...
I thought I should repost this since I was wrong about the part I was trying to get info on it's not the Ring gear drum (sorry)
My bad I'm talking about the carrier drum bushing it might help if I looked a little closer at the diagram (then just assuming) The carrier drum is held in place with the bushing riding on the center...
The bushings look pretty good they don't look worn they do have some scratch's but not too bad, I know this tranny was not taken care of almost 100 hrs on oil. I just can't find out what clearance it...
Yes it is a T20, I am in the process of rebuilding it and when cleaning the center plate up i noticed that the hubs needed to be sanded lightly, I then put the ring gear hub on the center plate to...
Does anybody have an idea how loose or tight the center plate hub in the gear drum bushing should be and should there be a little side play ?
Thank you will do
Also the wear I thought I had on the output shafts is a machined relief on the shaft when they make the splines, so no issues with the output shafts.
I believe I found the whine in the transmission, the input shaft bearing fell apart as I started to remove it from the output shaft, the needles had worn to a point on the ends on all of them, they...
I'm going to replace all the bearings since i can't realy see any thing wrong with the gears or any thing else, but i feel realy strong about the whine coming from the tranny so since I have it out...
How much wear should you see on the out put shaft from the shift collar?
I figured the stuff in the case was from break in since the oil hadn't been changed.