Thank You. Would anyone happen to know the correct part number for a 16hp downdraft carb (for a horizontal shaft motor)?
Type: Posts; User: pkarnezis
Thank You. Would anyone happen to know the correct part number for a 16hp downdraft carb (for a horizontal shaft motor)?
Is the carburetor the same for a vertical and horizontal motor? I've got a 14 and want some added oomph like the larger 16 but can only find vertical shaft motor near me. The Briggs part tree...
Is that not the exhaust routed forward? How can the motor breathe?
We call them rod caps or rod nuts. The specialty fastener section of the big box home improvement stores typically have them.
Installing a HF 3,000# winch. Installed the fabricated winch mount with backing plate and am going to mount the wiring block to the backing plate. Where is everyone routing the power cables? I want...
Looking for source for low cost caplugs or any ideas other than boat expanding plugs as they keep catching on stuff. Open to ideas.
If its a plastic tank just go to a toro dealer and get one from one of the snowblowers. It worked for me as mine was cracked. Sorry do not have a part number. Bring your old one if you got it. It's a...
Called R.A. today looking for a new throttle cable and was told my 95 max 2 has and old style throttle assembly and the new cables will only fit in the new throttle assy. What makes it so different...
Can I rest the assembled trans on the opposing output shaft or would you recommend something else? I don't want to mess up the case. The cracked output sprocket does not appear to be spinning or...
Where is the best place to get myself an output sprocket. It is a 15 tooth 1.75in i.d. piece. Motion Industries does not carry these. Thought they would. Hard to believe there is nothing else holding...
I've got a 94 MaxII I have been rebuilding as it sat for quite a bit with water in the tub. Fashioned myself some new chain tensioners and got me some new chains. I cleaned up the t20 got all the...
Has anyone ever had any luck custom ordering a cable? My Max II needs a throttle cable and I was thinking of getting one made with a nylon lining on the sheath and stainless cable material. Don't...
Thanks for the advice. It's a 1994 model according to RI. I was able to free up the shifters and got them out, cleaned lubed and put back in. Really smooth now.
Good engagement. Ive got to try and...
My 1994 MaxII had been immersed in water for an extended period of time. When I found it there was water about up to the top of the t-20.
All the chains, sprockets frame etc were well rusted. I...
I pulled the two plates that support the shifters to no avail. I tried prying a bit on them and could get them to move a little. Afraid of really tearing up something. Can I pull the shifters from...
Had to go out to check the gear selector situation. I can push the machine forward and back. The trans lever is in the lower position and when I push the machine the trans shaft spins so I do not...
Haven't been able to get out there to remove the chains and frankly wanted to wai til I was able to get the body off and get some close detail. Priority one is to stop the rot. Powerwashed most of...
Got the Max Hme on Sunday.
Took me two hours to clean out the tub. Powerwasher and Westleys Bleach-White worked wonders. Darned acorns kept getting stuck in the drain holes. Good news is the...
Hi all. Someone is giving me a Max 2. THe machine is from the mid 90's I think (serial#1113_) It looked to be in good condition from the outside but when we went to uncover it there was water...