Search:

maybe you contact them as a muddox customer?

1996 Max IV Kohler Command 20HP Running real good

OK i Finally figured it out..I Think
Dorman 610-041
also NAPA# NOE 6411017 @$2.33 each
Your milage may vary..
Thanks for everyones help.
Hope this helps someone else...

@oldstreetracer mine has serrated "ribs" on the shoulder for about 1/4" then 1" of thread

@ Rusty Gunn yes thats the one but I'm trying to source one in the valley. Wife's family from your area...

i even brought one in..no luck.
you got a link to the one you bought, it might give me info if nothing else...

Howdy,
Anyone got a part number for a max iv wheel stud?
i know its 7/16"-20..
when i try to source local, they want a make and model.
Its a 90's max IV...
blink..blink..blink is the responce I...

msafi65, thanks for the advice, i did find here for some template pieces, but not the big rear bolt on pieces..hmmm maybe make 2 like the front but extend down to bolt on???
max IV frame upgrade...

Amphibious Drew do you, or anyone, have drawing or link to those rear plates.
Also my T20 has studs in the trans, ant suggestions to remove them?
Much thanks

Congrands from the other side of the pond.
Please keep us updated with pics ;)

High, I'm in the mat valley, restoring a early maxII on the pic were the letteral sticks are touching, the serial number is stamped into the frame, they are sequencial numbers, do to my work scedule...

Do you mean 1/2" gas pipe?
and what is a nelson pin??
My "good stuff" pile does not consist of goody goods of this sort so I'll be making a home depot trip.
Thanks for the help!

Thanks for sharing Larry, this is a have to mod for me.
What size where the parts you used, especially the "collar" piece.
Thanks.

RacerOne3 thank you for the reply as I feel pretty confident about the carb at this point so this gives me my next dirrection. Also it's not charging the battery so maybe it's related.
Thanks for...

Thank you for the input everyone.with the idle a little higher it does not do it as bad.
No black smoke or back fire.
I stared at the carb for a long time trying to figure how it flows, there are...

Thank you for the replies, pulled plug and it was black and sooty,put a new one on as champions apparantly have a bad rep.
every diagram I've seen say that I have 2 idle needles, one is as it by the...

Thank you for replying Mike.
No air filter on at this time, so air should not be a problem?
Yes I am playing with needle settings, but they do not seem to make a difference in this aspect, matter a...

Title is a little misleading, if i slowly apply throttle it revs up fine.
If I just gun the throttle it spudders to death unless I release the throttle.
How/what would I trouble shoot??...

Richards Relics?

I bought some from Richards Relics, $90.00 a pair $175.oo for 2 pair.
Didn't want to mess with making them, seem good.

Anyone using the Vampires 22x12.5x12 on a MaxII?