teeko
Sophomore Slider

Hi yes my brakes are manual like an old snowmobile with round pucks for pads.
The adjustment shouldnt change until the pads wear quite a bit.
When the pads get hot they dont work as good so make sure they dont stick on when you are not using them.
I have seen where the roll pins are replaced with bolts but i dont know how much better that is.
I am in the process of replacing the 2 rear axles on the Bazooo.My sprockets are keyed to the shaft.

No time to work on the bazooo...still need to get an axle made.
Been busy getting ready for winter.

Hello teeko, I do not know about the speed difference between 2 or 4 stroke but my 2 stroke is a power house. I think you're limited with the 4 stroke, i meen the 2 stroke 2 cylinder 400 are over 40hp vs an 18 or 20 hp 4 stroke. The 2 stroke developes the rpm & get the power out very quick. I have a 9 inch driven clutch on my trans Verse the 10.890 i took off & my argo will go 50mph easily yet the way the engine clutch works it lets the rpm get up some before engageing so it does'nt bog from a start off. I hope you got a good muffler cause they are loud. This is my first argo also. I was lucky enough to find a complete argo for parts too last week. Maybe buy a cheep smomoble & use it's engine. Easy to drop in. Talk to ya soon. JK