2014SE
Master Mudder

Probably a good idea...I think if the banjo fitting was turned 180 degrees it would be ok...or just order one of the other longer lines and just put a loop in it...on another note...I thought you might be inerested in 2 simple modes I made..1 is to disconnect the start in neural wire on harness and rewire it to a small green led light on dash so when your out of gear it will light..#2 ..remove the grill under the hood scoop an recut to fit the cutouts in the hood...pop rivets with washers on the inside work well....also I bought 2 extra rubber mouldings from odg (used for the rear end of the tub) and put them at entry point for passenger and driver...this gives your hdi a finished look and you won't have to clean that area from leaves and branches..one other thing I did was ordered ARP stainless 6 sided bolts from summit racing and replaced the handrail and seat backrest screws..

2014se thanks for the up date on the transmissions, I see you have been busy adding a winter kit, what made you decide to go with wider tracks? were you sinking in the deep snow to much ? anyways they look awesome, you will have to let me know how they work. Well the wife told me if I didn't find a good use machine by Aug. to go and order a new one, so. that is where I am sitting right now. I want one for hunting season and to get out in the winter ,I feel like I am getting house bound this winter ,miss getting out in the bush and trails. Well I am off to work, for a couple of weeks, hopefully the weather changes around Innisfail and area.Have fun out there and keep the videos coming.
Rick

Called odg this morning...they said we should have no problem with that brake line..I guess thats good news...but I still think that now that it was signaled out...they will change it on future machines..

Later
Joe

Thanks for sending the pic...i too thought it was just mine..i can not believe odg did not see this twisted brake line...with all the vibration between the frame and engine I am sure this will become a problem in the near future....if this line leaks our steering will be lost..and you will be stuck.....this line needs replaced with a longer one... I will call odg today and find out if they think this is ok.

tracmaster

Hey 2014se....I have a sept 2013 hdi and feel my right side stainless steel brake line for the steering brake is badly twisted (installed wrong)..could you send me a picture of yours so I have something to compare to...its the shortest brake line
thanks tracmaster

2014se did you get your transmission change out ?I was wondering how that was working out for you. I was wanting to hear how your machine runs ;handles the tracks in the deep snow, did you get more speed out of it? I was hoping you could tell me the pro's and con's seen as you had a chance to run both transmissions in the same machine.(it would be the idea comparison)