thebuggyman1
Scaring frogs everywhere

Hey Jim,

Got a washed out, BUT just found my T20 bottom stud holes (3/8-16/.375) washed out.

Do you think I have enough casting on the inside boss to drill it out to 29/64"/.453 and put a Jergens insert in?
ed

Hi Jim. How have been? I havent been able to getto the t20 yet. I gutted and stripped the chap before i could get the motor running well enough to continuously test the t20. I needed the space and the engine was really starting to aggrevate me. 3 carbs and I couldnt get it to not blow gas out of the carb and not stall. I am going to rebuild it, block off the oil injection, formally, and put it in my attex racer. Like you I had no luck finding any info on the motor other than that it is apre 79, based on the carb setup.
If you dont want the granite state then I will give it to gonefishin. He really wanted it and I still need his Chap body. How is the Lil Truck coming?

I am new at posting. hope I am doing it right. I have a mo#1100 scrambler and am having a hard time removing the axels so I can redue the bearings. I have removed the wheels and hubs.there is a bearing on the out side and a sprocket on the inside. how do I seperate them to remove the shaft..

Hey...me and toys4me are going to bundy this saturday if you wana come out...im not sure what time yet tho

Hey Jim
How ya doing? I gotta question for ya. My 18 hp briggs was missing so I took the air cover off and saw oil around the top of the carb area and oil around the base of the carb. I added some seafoam to see if the valves are sticking a little and let it idle. With the air cover off it idles and runs good. With the cover back on it misses. There seems to be a little bit excess of oil around the top, I know a little is fine but this much seems like it could be part of the problem. Any ideas???

Hi Jim
I am very interested in how you made your UHMW bearing cages/extensions. I am in Afghanistan and sometimes I have to much time on my hands and I would love to try to make a set for my 2000 Max ll. Any help you could give me with dimensions and instructions would be awesome.

Thank you
Larry Grant

Hi Jim, I just saw your video on YouTube for the split shifter nice job..I like the location and the handle set up..

Sorry, meant to tell you i was in central indiana.

thanks for letting monoped know about me, finally got someone who can help me out with my machine!

Have you seen a yellow spring in a driven clutch? And he stiff is the spring in said clutch supposed to be. Should I be abl to collaps it easily by hand