I have a Max11 with the plastic tank. The PO had cut a hole in the side of the take to move the filler. I JB welded a piece of aluminum over the hole but it is still leaking. I bought some Kreem tank...
Type: Posts; User: vgilbertson
I have a Max11 with the plastic tank. The PO had cut a hole in the side of the take to move the filler. I JB welded a piece of aluminum over the hole but it is still leaking. I bought some Kreem tank...
Thanks for the info, I have been looking for a headlight swap. I ordered a set.
Max II with a Honda 62o engine. I have been running an electric fuel pump for a Kawasaki Mule but they don't seem to last long. Any recommendations? I have heard the pulse are not dependable.
Thanks...
I knew this was messed up when I bought it but looking for a repair. the PO had cut the tub for a bigger motor and the top of the fender cracked. I bought a piece of 1/4 inch plastic to glue to the...
Mike
Thanks for the reply - where did you buy the heat shield, I haven't seen one listed.
Thanks
Vern
built this this yesterday, the trails I have at the camp has branches hanging into the trail and my son said he needs a oh **** handle17179
Good afternoon
I have been running the Max II with the muffler inside the engine housing, do I need to get it outside the tube? it gets pretty hot in there and I am afraid of making the plastic...
I ordered a new gear and installed it this morning. Eaverything appears to be good but veer to the right when running straight. The right hand lever feels like it engages when you push or pull the...
I beat the axle out of the gear this afternoon. 95 and high humidity. the spacing is 7/8 on the larger one and 9/16 on the smaller, all 3 gears are 22 tooth. I chucked it in the lathe and it has...
I appreciate this forum, lot of knowledge in here. I have been ready posts tying to learn more about how to fix my problems so I out it up on paint cans and ran the drive system. The left hand jack...
excessive play on both sides Is this a spacer fix or something more?17132
What size are the lug nuts on a Max II 2000?
Thank you
17126
I picked this up to day and will have lots of questions. Motor will run but the tank needs to be flushed and carb cleaned. Need advice for exhaust and air intake on Honda 20 hp motor.
Thanks
Vern
https://norfolk.craigslist.org/snw/d/max-6x6/6616673517.html
Looking for opinions on the price, going to look at it this weekend.
Thanks
Vern
Went and looked at it this evening. Damange on both side of the front wheels ,holes, front left hand corner was pretty rough, looked like original motor. Pull start on the side wall but had what...
Thank you, that's the advice I was looking for
what is cheap enough? the guy want 700.00
Hello
There is a 69 or 70 scrambler for sale locally. I haven't seen it yet. Looking for advise on what to look for. Supposed to run and drive, no damage below water line.
Thanks in advance
Vern
Hello. Interested in AATV's, do not own one yet. have 24 acres I just purchased in Southampton county, VA that is polling hill pines with some low land creek and swap. I think a 6 wheeler would bea...