Well....believe it or not I got it out but it was a struggle
I got the battery tray out first but I had a hell of a time removing the axel
I couldnt hit the thrust bolt because no room to swing...
Type: Posts; User: jjort
Well....believe it or not I got it out but it was a struggle
I got the battery tray out first but I had a hell of a time removing the axel
I couldnt hit the thrust bolt because no room to swing...
Hello
The front right wheel on my Conquest hub weld let go and is no longer attached to the axel...can anyone tell me the procedure to get this particular axel out? Does the engine have to be...
I didnt know there was a vent line, I thought the cap would be vented...will have to check that out
thanks
Turns out I had a bad spark plug... never would have guessed that.... anyway goes to show you. Next time I have any problems, the first thing I am doing is changing the plug.... Thanks everyone for...
Hmmmmm it could be a bad coil.... they dont look like they are too handy to change
I have already replaced the pump with a Mr Gasket #42S but I suspect that the original pump is working fine... I thought I had found the problem as the tank doesnt seem to vent very well.... I...
No... I havent checked that.... I could connect an airhose and blow through it
Should the electric fuel pump be putting out a steady stream of fuel or should it be pulsing?
My fuel filter is never full... when I disconnect the fuel line at the carb and turn on the...
Thats a good idea with the leak down tester....will give it a try...... in the mean time, I rechecked the valve gap and it is fine.... I had too much oil in the engine so I thought that might have...
Thanks for the suggestions..... I did pull the carb apart and it looked pretty clean inside.... blew out all the jets with compressed air after.
at this point I am thinking about replacing the...
engine starts fine and runs great in neutral...revs up no issues but after it warms up and under load it starts to backfire and lose power.... If I back off the throttle it will run ok but as soon as...
I have a Conquest and they do not swim at all...kind of bob along... I have also been able to throw a track while trying to get out of a ditch...I think my tire pressures were too low...since I...
Hmmmm I will give it some thought...I didnt take any videos but picture an argo just floating and not going anywhere lol. I tried different speeds but didnt make much difference.
I am not sure why...
I can confirm that these tracks do not swim at all
I might make some rubber paddles to see if that will help
I know what you mean..however when you are floating and trying to get up an uneven bank, sometimes the optimum angle is not in the cards... I really was just seeing what kind of trouble I could get...
If I get a chance later today, I will set up the gopro, put on my chest waders, load up my 3 foot winch picket and try to recreate the walking out of the track.
The left hand side came off. It took me quite a while to get out..I am pretty sure it was because of the track tuners. I had to hit the brake on the left side and pivot around with the track which of...
I really had to work at it.... was quite surprised but I think they have too much slack.... I put more air in the corner tires...see what happens now
I am actually having fun seeing how bad I can...
I deliberately go looking for trouble in my creek and believe me, I found it today
I was floating and trying to get back up the bank backwards. One side grabbed and the argo lurched sideways and...
Awesome
I will give adair a shout