Thanks Wedge i'll try that, just called Duromax and the guy told me the vent on top of the tank will stop up with gas if gas gets in it. I guess you can't run the tank that comes on theDuro Max if...
Type: Posts; User: CROSSBOW
Thanks Wedge i'll try that, just called Duromax and the guy told me the vent on top of the tank will stop up with gas if gas gets in it. I guess you can't run the tank that comes on theDuro Max if...
I don't know what to do with it. It runs good untill you run for a while. Someone said the gas was boiling in the tank. I saw on this site where a lot of guys were installing these and thought it...
Mike there is no vent like on a boat gas tank.
Ok guys i put the engine in my Max II a took it out for a spin, after a while i heard a loud pop and turned around to see my gas cap falling from the sky.I noticed it started flooding before the cap...
I'll post a pic. when it comes.
:DSwapping the old 14 hp Briggs for a new 16 hp Duromax.
It sounds like your belt is to loose. Had the same thing with mine .
Placed my new ladder stand on top of my max and floated down the creek to my new hunting spot, pulled up to the tree and hung a pulley to the tree and winched my stand into place. I love my...
Looks good Jim
Found the trouble got it going Thanks Tim.
Thanks Tim who ever put the winch on did wire it the lights .Do you know which wire on the switch is the hot wire? I've looked every where and dont see any fuses
Hey guys i was running the winch today to anchor my Max II down to the trailor and every thing quit working.I thought the battery went dead but after charging the battery still nothing.Checked the...
woot mine did the same thing. My belt was loose and it wasn't shifting into high, Jay at RI told me to tighten the belt . Slide the motor to the rear of the max. If the Max moves while idle its to...
LOL , I knew it was comming and i'm a newbie:rofl:
Roy i wish i could go and watch the big block in action but the funds are low after my rebuild, Good luck my friend can't wait to see the vids.
Sounds good .
Hope you get it running soon Roy thats one nice 6x6. My new bearings should come Monday i hope.
Thanks Jim, they sent the wrong bearing. the new bearings are HC 206-20 R3,the old bearings are SA 206-20. T HE FLANGE is the cast iron 2 bolt flange that mounts inside the body that the bearing fits...
Just watched Mike's Vid. again and bearing he used didn't have a lip on the back side.
Yes i took the nipple out ,the back of the bearing hits the frame and holds the flange 1/4" away from the frame. My old bearings didn`t have the lip on the back side of the bearing.