hydraulic cylinders/pistons put or relieves pressure on opp side to turn to works off steering wheel this model
Type: Posts; User: peterjr69
hydraulic cylinders/pistons put or relieves pressure on opp side to turn to works off steering wheel this model
13.5 ya I will once im done with the minor tweaks
ARGOJIM------------ I tired to reply but your mail box is full I used 30mm 6206-2rs I bored the id to 1.1875 the inner bearings are same an the holders I got here Manitou Mfg. Co. Two Bolt Rubber...
the steering is good the brakes work.updated a lot of the items all new u cup seals cleaned and honed cylinders no leaks real bleeders from this era,lol new clutch material all new bearings and...
thanx I got the motor manual im just not sure how the governor is set and if the butterfly was put in right,prob scrap it and get a 13hp
I cant seem to get a clear pic of how governor is set someone had this apart and messed it all up is a 170402-0215-01 for scrambler
these look like stock axles?http://i36.photobucket.com/albums/e32/peterjr69/IMG_6528_zpsecad430d.jpg
heres it ready to bleed just all test...
I replaced the bleeders -grease fittings I assumed but the oil leaks out of the ball tip on fitting it there anything else that is used or is better? but I have made some progress...
are those original axles?also where did you get wheel hubs?
i made a fixture to hold standard 6206-3206 bearings and I just circle mill the id worked out great..
got one last hope find out at end of jan what I gonna go
ok seems all axles bent bearing at the body I cant find one to work I think I part out and call it done.to hard to find axles and sprockets...
I found all the special rubber mounted bearings and axle bearings so we will see if they work ...I let you know where to get them if needed
you can email them and also the bearing info to please was gonna change them cause they are pretty shot thanx for the input I appreciate it peterjr69@yahoo.comPLUS I don't have a tensioner I have to...
if I change the wheel sprockets should I go smaller to get top end?
yes they mic up 1.182 which is 30mm but 1.1875 3/16 will work too all 6 drive wheel axles
my scrambler seems to be getting to the point where I may just part it out I noticed a couple axles bent and drive sprockets on each are shot tried replacing bearings and shafts are either 30mm or 1...
allset its in two pieces thanx
I welded the ones I had and re machined them that all works now
http://i36.photobucket.com/albums/e32/peterjr69/image_zps531e5b57.jpghttp://i36.photobucket.com/albums/e32/peterjr69/image_zps6bdbd790.jpgI have the u cup seals both sizes and fibers for clutches I...