Listed for sale:
1971 Kid 8x8 Amphibous ATV 30HP Wisconsin VH4D Vickers Hydrualics | eBay
Type: Posts; User: s_winkler04
Listed for sale:
1971 Kid 8x8 Amphibous ATV 30HP Wisconsin VH4D Vickers Hydrualics | eBay
So after getting the KID up and running a couple things have happened. The rear output PTO shaft seal went out. I found that my set screw on the PTO shaft let loose and allowed the PTO shaft to slide...
I bought my steer cables at truck parts, as close of a match I could find. Part #6203BBU072
Well I can say the kid is 99% built. Got the seat built, floor pan in, lights hooked up, and drove it around. It was a good feeling. The kid performed as I expected for a 30hp engine. Had to do some...
another update to the build. front snow plow mount is built, need to put on the mounting tabs to mount the plow still. Body is on and bolted in place. electrical hooked up. oil is in. working on...
Update to the KID. Engine and powertrain installed and triple chain hooked up. Body is repaired and should be water tight. I went with flat camouflage tan for the body color. The black areas is...
here are some pictures of the rolling chassis with chains installed. next step is to install the engine & powertrain.
13590
13591
13592
I have the engine and powertrain completely painted and ready to drop in. The paint scheme turned out really well and cleaned up nice. All new carrier bearings and seals are replaced. Axle shafts are...
13504135051350613507Time for an update, it has been a while. I bought a sand blaster (new project new tools) and sand blasted the entire under carriage. I didn't get every piece of paint and dirt off...
How did your KID handle in the snow MyNewKID?? Did you still have the clunking chain noise after replacing the chain? Where did you go to get your chain and what did it cost? I haven't started...
OUCH! That is unfortunate that happened, sounds pretty severe. Post some pictures if you could, would like to see it. I don't have any extra parts and have been trying to search for anything online...
Thanks for joining the post everybody! I am glad it is helping more people than just me!!
On the pull cables, if you can get some PB blaster and spray the cable it will soak into the cable and...
1317213173131741317513176Got some more work done on the KID. Since the upper body was removed, my next step was to pull the engine and power train assembly. With my luck, the 4 bolts that held the...
Located in south central Kansas
13106131071310813109
Thanks for the feedback. Yes that is a aluminum fuel tank behind the driver seat, something the farmer installed. He also relocated the battery and put a single stat...
I have started tearing the KID down. I have broken off more bolts on this machine then I have in my lifetime of wrenching, got to love rust and small bolts! My plan is to split the body, separate the...
Thanks for viewing my thread. I joined 6x6 world not very long ago and consider myself a newbie/rookie to the AATV world. I picked up this KID 8x8 from a farmer who used it back in the day to pull...
I just purchased a KID. It runs and drives good, but needs some TLC. I am hesitant of tearing into it for a restore as I am not able to find any parts. I am open for suggestions as well for sourcing...