Hello, new here, just bought a scrambler hoping to get it up and running. The engine starts and runs good, but when I give it gas to move it seems like to two plates don't grab to make the wheels move, I have no idea where to start. Any help to point me in the right direction would be awesome.
Start with the manuals section of the home page, sounds as if the friction material is wore or gone.
My new beer holder spilled some on the trails - in it's hair and down it's throat.
Joe Camel never does that.
Advice is free, it's the application that costs.
I down loaded the Manuel but since the images are not crisp or zoo able. It's hard tell part numbers. Also would the friction material have an effect on steering?
pics of the plates would help.. especially if there is noticeable gaps between them. on the 1100 series the lining material is only 1/2 wide and 1 1/4 - 1/2 long. i just did a scrambler 1000 i wound up using 1200 series for the bigger clutch material. look between the plates and see if there is missing linings
If it don't have 6 wheels and floats.. isn't any good to me. Have you ever tried floating a 4 wheeler across a pond... Doesn't work very well does it?
I don't have anything thing you reference to determine if theses are good or bad
Well like the brake shoes, there should be individual little visible pads between the 2 round drive discs, not seen.
My new beer holder spilled some on the trails - in it's hair and down it's throat.
Joe Camel never does that.
Advice is free, it's the application that costs.
Posting Permissions
Reply With Quote
