need a drive belt for newt the bold

[glennmac]

I would like to buy a new belt for Newt, I don't know where to get one though.
My ballpark measurements come out to 54 3/8" long and 1 3/8" wide. Does that sound
close? The Challenger part number on the old belt is 11135 there is also a 49v on it.
Any help would be appreciated. Tried searching replacement belts, and looking for online charts but so far nothing.

[msafi65]

Look in this place and see if it's a variable speed belt. I've been purchasing variable speed belts for some machines from vbelt guys. http://www.optibelt-usa.com/fileadmi...ED_CATALOG.pdf

[glennmac]

Look in this place and see if it's a variable speed belt. I've been purchasing variable speed belts for some machines from vbelt guys. http://www.optibelt-usa.com/fileadmi...ED_CATALOG.pdf

I sent these guys an email over the weekend, they have not replied.

[msafi65]

Didn't word the response well. Try v belt guys and search for a belt of proper width. Your old number sounds like variable speed belt. Buffalo trucks with comet clutches use a 19 wide 30 degree belt, thus 1930v the length is the last three or four digits.

[allwheeldrive]

McMastercar has a good selection https://www.mcmaster.com/#v-belts/=16ds8vf
But for the price I'd look elsewhere when you find a part number that's what I did.

[glennmac]

Thanks for the suggestions guys, I checked all the sights out and can't find anything close. the difficult part is the length, 54".