You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact us. Looking forward to seeing you in the forums and talking about AATVs!
Hi, just recently experiencing some nasty steering problems with my centaur. It's operating in a very cold environment (Norway), I started to get trouble with steering for a few weeks ago when it just didn't work at start. (I have hydrostat system). After running the motor for 5min in idle, it was ok. Than it didn't work anymore. After I heated it up at night in my garage (not isolated) with heaters and so on. It again worked fine for a while.
But since last week the steering is totally a mess, it still only works when not driving. to the left normal, to right very slow. But today it was just the otherway around! when not steering the Argo it can just suddenly start to spin. sometimes i got some of the steering back, while driving for like a few seconds, and than gone again. As i said in 0 speed it works for a bit .
Anyway, changed oil, level is being checked every day. Filter is shifted out. No traces of metal pieces in the old oil.
What could this be?
-moisture in the transmission?
-transmission failure?
-hydrostat pump is not operating properly?
Anyone experienced the same?
Here are a few things to consider, all of which are general to hydraulic systems. I have never seen a Centaur.
1) if you have the old hydraulic oil filter, cut it open and inspect the folds. See if you can see any metal. If the pump is failing the metal will catch in the filter rather than being obvious in the oil.
2) Check all your steering linkage (if it has any). Make sure all linkage is tight and providing full movement as it should.
3) If your hydraulic system relies on a reservoir that is located away from the pump, check to see that the suction line is good and sturdy and not sucking together and starving the system for fluid.
4) Someone with more knowledge than me will have to give you guidance on the specifics, but you may have a bypass valve that is failing, depending on how the system is made. If you have a failing bypass valve, it will just dump the fluid back into the reservoir rather than delivering pressure to the drive motor(s).
5) Make sure you have the correct fluid. It is not unheard of for incompatible fluids to foam and not do their job. Also, do you have the correct viscosity fluid for your operating temp?
6) Surely you have checked for leaks. If you have one it should be pretty obvious.
7) There should be a way to attach a hose and gauge to the pump to check the pressure it generates. If you aren't producing pressure, or enough pressure, or enough flow, you aren't going to go. This pressure test is also related to the bypass valve i mentioned above. Someone will have to give you the working pressures and instructions on the test procedure.
8)I'm not sure how the hydraulic pump is driven (belt, direct connect) but make sure there is no slippage going on.
9) If there are any electronics that control the hydraulics, that is a whole other can of worms - sensors, calibrations, etc.
not familiar with the Centaur but it looks like the hydrostat is directly connected to the steering shaft and spins along with the gear trans and acts on the differential for steering. AKA dual differential tank drive. The belt drive from the trans to the hydrostat would be critical for proper steering as well as the connection from the steering column to the hydrostat. The proper oil viscosity will also play a critical role in the operation.
Hi, thanx for your answers! the manual i have. It helps a lot for understanding of the system.
These answers helps a lot. I just have to check some of them which i didn't do yet. specially the belt.