Belt question
OK...the crossover I traced down was a epic failure....so I'm going to measure the belt I need out myself...these are my questions...with the engine not running when the belt is on the primary how far down does it ride? In other words does it touch the hub in the center of the assembly? If it does is there any play side to side in it? (2nd question) Where does the belt ride on the secondary? does it ride flush with the top or is it ride down inside? I figure I can take measurements and get close....or if someone can measure there belt or give me the part number of a belt that works well with there machine I would be forever greatful...spending $40-$50 per belt to find out there wrong is starting to irk me (not to mention undoing all the stuff to get the belt on and off)...thanks
A person who says "anything is possible" obviously has never tried to staple jello to a tree....