Surely there is a 20" x 11" tire out there that you can find. Maybe someone knows right off hand and will advise you Buy the way, nice buggy
Nice Machine!!! Lot's of fun to work on them... I may have some plastic floor pans for ya if you need some. I am in Ontario as well. PM or email if your intrested.
Have fun with the cleanup!!!!!
Dezi Gebel
2 Early 70's Argo's Will Merge To Make One!
Hi Racerone3;
I had a 1984 argo 8x8 with a Kohler twin 17 that I used for work & play for 23 years. When I sold the machine it was on the third set of spark plugs. It was a very dependable motor. It had 2200 hrs on it when I sold it. I'm surprised that you used so many sparkplugs.
Ride Safe
EWS
Weee Innisfil, I ride my bike through there quite a bit.
'70's Argo 6x6 - Rebuilt from the ground up. Briggs 18HP Opposed Twin.
Go where you want, don't get stuck, keep the rubber side down.
took a few more pictures guys.found the easy way to work on these suckers,split the shell.now i gotta get some chain,sprockets and bearings ordered.
I know we have used them on machine at Busco before. When those pins snap it will not pull good. You may want to consider a axle upgrade while you are at it. Splined axles and sprockets would bring that machine into the 90"s. I am not so familiar with you bearing configuration but before i bought old style material i would consider the newer upgraded axles. Just a thought. New up to date axles are not all that bad as far as price.
Last edited by lewis; 03-26-2010 at 09:31 PM.