Are you going to swim this machine?? Just wonder if you thought about that with the entire axel being cut for the keyway....
Are you going to swim this machine?? Just wonder if you thought about that with the entire axel being cut for the keyway....
I don't think that would pose a major problem. just put a squirt of silicone in to fill the void of the keyway where it goes through the bearing
A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed.
good point, I had not thought about that, but I like the silicone idea. was looking at the current axle and had another idea too. could get some 2 inch quarter wall tube and weld all 3 center sprockets onto it and then just drill a couple 1/4 inch holes through the axles and stick some grade 8 bolts in there. that would be 2 axles that don't need keyways then. . Will have to wait till I have everything out to decide for sure which way i want to go about it...
2000 Land Tamer with Tracks.