You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact us. Looking forward to seeing you in the forums and talking about AATVs!
How long usually does the flywheel that creates electricity to charge the battery last for I don't think it has ever been replaced in my 1992 magnum so would that be the reason why my battery is not charging
The flywheel should never wear out. It's just a big hunk of cast iron. There are magnets glued to the inside & they MAY have broken loose but more likely it's the voltage regulator or stator.
I would suggest checking or replacing the rectifier/regulator. I had an Argo I/C with the Kohler 17 hp engine that stopped charging. At first I misdiagnosed it - I bought a stator, thinking that it was the culprit. But it was the rectifier/regulator. Once I replaced it, the engine charged just fine.
I'm assuming of course that you have a Kohler engine.
you can test the stator out put with a volt meter if you have one. disconnect the two outside leads on the rectifier and connect volt meter to 200 volts a/c and crank engine run up rpms and it should read between 25 and 30 volts a/c. if you don't get that voltage it is not working. if you get 25/30 volts a/c than test rectifier it will be the center lead and it should read 13/15 volts dc.
this is a addon from all the other posts about the wiring in my magnum. i traced a yelow wire that comes from the fuse block, goes to solonoid then from the solonoid to black wire with green fuse on it. then it is connected to another yellow short wire that then goes to a black plastic conector and to regulator. would that have an effect on my charging or?
Last edited by Mike; 01-29-2016 at 09:36 PM.
Reason: merged two threads on the same topic
ok so would i have to replace the wire? the wire was left un taped for a while because i didnt notice it. and it was a little rusty and some wire sticking out of it?