Does anyone know how to separate an axle from the hub on an old Attex?
Does anyone know how to separate an axle from the hub on an old Attex?
Are you talking the slip over part with the bolt through it? If so I usually drill a large hole in the center so I can press it out wit piece of shaft. Usually have to put in a press and heat the sleeve while under pressure. I clean inside with a flap wheel on a drill extension.
If it’s the “cone” style aluminum hub, there is a snap ring you access from the inner (body side) of the hub. It’s deep down there and you’ll need a good set of snap ring pliers.
#1 Attex ST/300/D - "The Duck." Restoration of my family owned aatv from the early 1970's.
#2 Attex ST/300/D - Resto/Mod project for the trails
#3 Attex 440 Thunderchief Racer
#4 Attex ST/400 Trail Machine
Hey Duck. I have some from a st300d if that's what you're looking for. Aluminum cone 3 bolt I think. I can get pic tomorrow
This it?
Last edited by rickga; 01-06-2022 at 07:16 PM.
Sorry wrong thread. DisregardOriginally Posted by Duck89
Posting Permissions
Reply With Quote