max 4 #10937 frame specs t-20 location

  1. Welcome to 6x6 World.

    You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact us. Looking forward to seeing you in the forums and talking about AATVs!
+ Reply to Thread
Results 1 to 6 of 6

Thread: max 4 #10937 frame specs t-20 location

  1. #1

    max 4 #10937 frame specs t-20 location

    MY frame in the T-20 lower mounts is wore sloppy in mount holes. I've found the specs on the frame reinforcement. thank you. i'm looking for bolt hole location front to back on frame. thanks ahead of time,hank

  2. #2
    Join Date
    May 2010
    Location
    Fairbanks AK
    Posts
    1,455
    I don’t have measurements but always set the reinforcement plates level with top of front part of frame. If the t20 sits 1/8” low you loose a lot of the rear chain adjustment. If frame is bent down it should be pulled up as close to true as possible before installing reinforcements.

  3. #3
    thank you for the input. I always had belt alignment issues. i finally tore the machine down for all new axle bearings. had 5 short axles 1 long, 1 rear sprocket was longer.
    wouldn't allow chain alignment. ended up needing 2 axles and 2 center sprockets , and new chain. should be a good machine after this. thanks again, hank

  4. #4
    Join Date
    May 2010
    Location
    Fairbanks AK
    Posts
    1,455
    I forgot to mention an improvement that is easy when transmission is out. Turn about 3” of the top frame rail down on clutch side. 3/8” is good on center with the clutch. It can be done with adjustable wrench. This mod gives more belt clearance.

  5. #5
    Join Date
    Jun 2014
    Location
    North Eastern NC
    Posts
    370
    If you are able, try this mod from @onlyonce.
    I love it.
    http://www.6x6world.com/forums/max-a...earings-8.html

  6. #6
    thanks, I also found some frame photos that are a big help. Thank you everyone, Hank

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts