k341 kohler points adjust with engine installed

  1. Welcome to 6x6 World.

    You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact us. Looking forward to seeing you in the forums and talking about AATVs!
+ Reply to Thread
Results 1 to 6 of 6

Thread: k341 kohler points adjust with engine installed

Hybrid View

  1. #1

    k341 kohler points adjust with engine installed

    Hey guys, I replaced the points on my 945 but I'm having trouble being sure I'm at top dead center for the adjustment. I cannot look into the blower sight hole because the engine is installed. I think watching for the push rod to move the points should get me there. Would that work or is there a better way to tell? It is easy to find how to do the adjustment on the bench or on a mower but down in the tub it is tricky. Thanks for any help you can offer, Rob in Arkansas

  2. #2
    Join Date
    Feb 2016
    Location
    Mississippi
    Posts
    1,108
    Can you pull the spark plug and run a piece of coat hanger or similiar down the hole and touch the piston? Then watch the hanger move up or down. Make sure the hanger is long enough that it can't be lost in the cylinder.

  3. #3
    i can do that
    Thanks for the tip
    I'll try that today

  4. #4
    Join Date
    Dec 2018
    Location
    Muskoka, Ontario
    Posts
    95
    You don't realy need to be that precise. The points are open for a long time it should be easy to tell. Just gotta nail the gap setting when they are open

  5. #5
    Hey guys I figured out how to see my timing marks with the engine in the tub

  6. #6

    adjust timing with engine installed

    Hey guys, I figured out how to set my timing with the engine installed. It's a K341
    I cleaned the flywheel with sandpaper on a pencil.
    I removed the blower housing rubber boot.
    I could see the marks better there so I highlighted them and added a mark on the pull rope assembly to help me find the timing marks in the site hole.
    I used a mirror and a flashlight to line up the S mark in the site hole with the raised timing reference mark.
    I adjusted the points gap at the S mark.
    It fired right up and idled just fine.
    I had adjust the gap when it was open wherever and it just would not fire at the right time. The timing marks put me right.

    Thanks for the support on this and many other obstacles during my rebuild.

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts