artic cat 340 motor on an attex?

[LarryW]

I would be ok with a different exhaust setup but if it were spun around wouldn't the tranny spin backwards??

No, just the top end, the bottom of motor stays the same rotation. The rotation is basically set by spark timing and the direction of the pull rope. Both of which is on the lower end. And not every motors cylinder stud patterns are the same on both sides so you can't always do that.

[ArgoH2]

so i don't actually spin the whole engine around to fit just the heads hmmm I wish someone on here has done this before

[ArgoH2]

maybe I should stick with the 297 in it now and just get a coil but will a reg car coil work like it was setup before???

[Amphiman1]

I would be ok with a different exhaust setup but if it were spun around wouldn't the tranny spin backwards??

As long as the motor is spinning clockwise,,, as u r looking at the pull starter, it will be fine if you don't want that motor, let me know,,,,,

[George]

heres a pic of a 340 http://www.snowmobilelinks.com/Quad%20Plug.jpg


how do i install it to be correct

That engine is not fan cooled. I don't think it'll do too well inside an Attex.

[ArgoH2]

I ended up not getting the motor today because I thik my 297 is fixable and runable. I can get the 340 in a sled no for 75 bucks the guy said.

[Amphiman1]

I ended up not getting the motor today because I thik my 297 is fixable and runable. I can get the 340 in a sled no for 75 bucks the guy said.

GIMMNE!!!! pm me